Re: [PATCH] Input: atmel_mxt_ts - fix reset-gpio for level based irqs

From: Nick Dyer
Date: Sat Apr 21 2018 - 16:11:51 EST


On Fri, Apr 20, 2018 at 09:42:07PM +0200, Sebastian Reichel wrote:
> On Fri, Apr 20, 2018 at 02:44:02PM -0300, Ezequiel Garcia wrote:
> > Hi Sebastian,
> >
> > On Fri, 2018-04-20 at 19:24 +0200, Sebastian Reichel wrote:
> > > The current reset-gpio support triggers an interrupt storm on platforms
> > > using the maxtouch with level based interrupt. The Motorola Droid 4,
> > > which I used for some of the tests is not affected, since it uses a level
> > > based interrupt.
> > >
> >
> > I found this confusing. Interrupt storm happen with level-based interrupts,
> > but the Droid4 is not affected?

Can I ask what happens during the interrupt storm. Are you getting lots
of the "failed to read T44 and T5" message, or something else?

> > > This change avoids the interrupt storm by enabling the device while
> > > its interrupt is disabled. The following mxt_initialize() requires,
> > > that the device is responsive (at least mxt224E is unresponsive for
> > > ~22ms), so we wait some time. We don't wait for leaving bootloader
> > > mode anymore, since mxt_initialize() checks for it anyways.
> > >
> >
> > IMHO, having some more or less arbritrary sleeps is almost
> > always a problem. This value might be enough for some platform,
> > might be too short for some other, and then it might get too large
> > for someone else.
>
> The 22ms chip-being-unresponsive are not newly introduced. The
> same 22ms are also required for soft-reset. I did introduce a
> new time (MXT_RESET_GPIO_TIME) for the "chip being reset" state,
> since my randomly chosen 200ms from before were exaggerated
> considering all mxt datasheets I checked stated only a few nano
> seconds.

According to the data sheets there is a period after a reset where the
CHG line is temporarily set as an input, during which the host should
ignore it. If you don't, you might get a stray interrupt and try and
communicate with the device, which might leave it in a bad state. I
think you mentioned that later in your email.

The reset time varies per chip, but the 100ms in mxt_soft_reset() was
based on discussions with app support at Atmel, so should be correct in
most cases.