[PATCH 2/4] ARM: dts: stm32: add PWM pins used on stm32mp157c-ev1 board

[Fabrice Gasnier]

stm32mp157c evaluation board has following PWM pins available on GPIO
expansion connector:
- TIM2_CH4 (PA3)
- TIM8_CH4 (PI2)
- TIM12_CH1 (PH6)

Signed-off-by: Fabrice Gasnier <fabrice.gasnier@xxxxxx>
---
 arch/arm/boot/dts/stm32mp157-pinctrl.dtsi | 27 +++++++++++++++++++++++++++
 1 file changed, 27 insertions(+)

diff --git a/arch/arm/boot/dts/stm32mp157-pinctrl.dtsi b/arch/arm/boot/dts/stm32mp157-pinctrl.dtsi
index 6f044100..867cfeb 100644
--- a/arch/arm/boot/dts/stm32mp157-pinctrl.dtsi
+++ b/arch/arm/boot/dts/stm32mp157-pinctrl.dtsi
@@ -158,6 +158,33 @@
 					bias-disable;
 				};
 			};
+
+			pwm2_pins_a: pwm2@0 {
+				pins {
+					pinmux = <STM32_PINMUX('A', 3, AF1)>; /* TIM2_CH4 */
+					bias-pull-down;
+					drive-push-pull;
+					slew-rate = <0>;
+				};
+			};
+
+			pwm8_pins_a: pwm8@0 {
+				pins {
+					pinmux = <STM32_PINMUX('I', 2, AF3)>; /* TIM8_CH4 */
+					bias-pull-down;
+					drive-push-pull;
+					slew-rate = <0>;
+				};
+			};
+
+			pwm12_pins_a: pwm12@0 {
+				pins {
+					pinmux = <STM32_PINMUX('H', 6, AF2)>; /* TIM12_CH1 */
+					bias-pull-down;
+					drive-push-pull;
+					slew-rate = <0>;
+				};
+			};
 		};
 
 		pinctrl_z: pin-controller-z {
-- 
1.9.1