Re: [PATCH v5 15/15] devicetree: bindings: Document qcom,pvs

[Rob Herring]

On Thu, Dec 21, 2017 at 5:53 AM, Sricharan R <sricharan@xxxxxxxxxxxxxx> wrote:
> Hi Rob,
>
> On 12/21/2017 2:48 AM, Rob Herring wrote:
>> On Wed, Dec 20, 2017 at 11:55:33AM +0530, Sricharan R wrote:
>>> Hi Viresh,
>>>
>>> On 12/20/2017 8:56 AM, Viresh Kumar wrote:
>>>> On 19-12-17, 21:25, Sricharan R wrote:
>>>>> +  cpu@0 {
>>>>> +          compatible = "qcom,krait";
>>>>> +          enable-method = "qcom,kpss-acc-v1";
>>>>> +          device_type = "cpu";
>>>>> +          reg = <0>;
>>>>> +          qcom,acc = <&acc0>;
>>>>> +          qcom,saw = <&saw0>;
>>>>> +          clocks = <&kraitcc 0>;
>>>>> +          clock-names = "cpu";
>>>>> +          cpu-supply = <&smb208_s2a>;
>>>>> +          operating-points-v2 = <&cpu_opp_table>;
>>>>> +  };
>>>>> +
>>>>> +  qcom,pvs {
>>>>> +          qcom,pvs-format-a;
>>>>> +  };
>>>>
>>>> Not sure what Rob is going to say on that :)
>>>>
>>>
>>>  Yes. Would be good to know the best way.
>>
>> Seems like this should be a property of an efuse node either implied by
>> the compatible or a separate property. What determines format A vs. B?
>>
>
>  Yes, this efuse registers are part of the eeprom (qfprom) tied to the soc.
>  So this property (details like bitfields and register offsets that it represents)
>  can be put soc specific and nvmem apis can be used to read
>  the registers. Does something like below look ok ?
>
>  qcom,pvs {
>         compatible = "qcom,pvs-ipq8064";
>         nvmem-cells = <&pvs_efuse>;
>  }

Why do you need this node? It doesn't look like it corresponds to a
h/w block. It looks like you are just creating it to instantiate a
driver.

>  qfprom: qfprom@700000 {
>         compatible      = "qcom,qfprom";

Either this or...

>         reg             = <0x00700000 0x1000>;
>         #address-cells  = <1>;
>         #size-cells     = <1>;
>         ranges;
>         pvs_efuse: pvs {

a compatible here should be specific enough so the OS can know what
the bits are.

>         reg = <0xc0 0x8>;
>         };
>  };