[PATCH 06/12] ARM: dts: imx6-tx6: specify ethernet phy reset post-delay

From: Lothar WaÃmann
Date: Tue Oct 17 2017 - 04:57:28 EST


Under certain circumstances the ethernet PHY cannot be detected on
Ka-Ro electronics TX6 modules. Using a phy-reset-post-delay of at least
2ms alleviates this problem. Define it to 10ms to be on the safe side.

Signed-off-by: Lothar WaÃmann <LW@xxxxxxxxxxxxxxxxxxx>
---
arch/arm/boot/dts/imx6qdl-tx6.dtsi | 1 +
1 file changed, 1 insertion(+)

diff --git a/arch/arm/boot/dts/imx6qdl-tx6.dtsi b/arch/arm/boot/dts/imx6qdl-tx6.dtsi
index aa32956..c6b2d63 100644
--- a/arch/arm/boot/dts/imx6qdl-tx6.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-tx6.dtsi
@@ -249,6 +249,7 @@
clock-names = "ipg", "ahb", "ptp", "enet_out";
phy-mode = "rmii";
phy-reset-gpios = <&gpio7 6 GPIO_ACTIVE_LOW>;
+ phy-reset-post-delay = <10>;
phy-handle = <&etnphy>;
phy-supply = <&reg_3v3_etn>;
status = "okay";
--
2.1.4