Re: [PATCH v2 2/3] i2c: davinci: Add PM Runtime Support

From: Sekhar Nori
Date: Tue Aug 22 2017 - 01:23:32 EST


On Tuesday 22 August 2017 06:47 AM, Franklin S Cooper Jr wrote:
>
>
> On 08/21/2017 04:05 AM, Sekhar Nori wrote:
>> On Thursday 17 August 2017 03:47 AM, Franklin S Cooper Jr wrote:
>>
>>> @@ -802,7 +821,6 @@ static int davinci_i2c_probe(struct platform_device *pdev)
>>> dev->clk = devm_clk_get(&pdev->dev, NULL);
>>> if (IS_ERR(dev->clk))
>>> return PTR_ERR(dev->clk);
>>> - clk_prepare_enable(dev->clk);
>>>
>>> mem = platform_get_resource(pdev, IORESOURCE_MEM, 0);
>>> dev->base = devm_ioremap_resource(&pdev->dev, mem);
>>> @@ -811,6 +829,18 @@ static int davinci_i2c_probe(struct platform_device *pdev)
>>> goto err_unuse_clocks;
>>
>> This goto is wrong now. There is no need to unwind the pm_runtime setup
>> on a devm_ioremap_resource() failure. You can just return error here.
>
> Ok
>>
>>> }
>>>
>>> + pm_runtime_set_autosuspend_delay(dev->dev,
>>> + DAVINCI_I2C_PM_TIMEOUT);
>>> + pm_runtime_use_autosuspend(dev->dev);
>>> +
>>> + pm_runtime_enable(dev->dev);
>>> +
>>> + r = pm_runtime_get_sync(dev->dev);
>>> + if (r < 0) {
>>> + dev_err(dev->dev, "failed to runtime_get device: %d\n", r);
>>> + goto err_unuse_clocks;
>>> + }
>>> +
>>> i2c_davinci_init(dev);
>>>
>>> r = devm_request_irq(&pdev->dev, dev->irq, i2c_davinci_isr, 0,
>>> @@ -849,10 +879,16 @@ static int davinci_i2c_probe(struct platform_device *pdev)
>>> if (r)
>>> goto err_unuse_clocks;
>>>
>>> + pm_runtime_mark_last_busy(dev->dev);
>>> + pm_runtime_put_autosuspend(dev->dev);
>>> +
>>> return 0;
>>>
>>> err_unuse_clocks:
>>> - clk_disable_unprepare(dev->clk);
>>> + pm_runtime_dont_use_autosuspend(dev->dev);
>>> + pm_runtime_put_sync(dev->dev);
>>> + pm_runtime_disable(dev->dev);
>>> +
>>> dev->clk = NULL;
>>
>> This null setting of clk seems quite bogus and can be cleaned-up.
>
> Do you mean that I should just remove this line?

Yes, and I noticed a similar line in at least one more place that can be
removed as well.

Thanks,
Sekhar