[PATCH v2 14/16] mmc: meson-gx: implement voltage switch callback

From: Jerome Brunet
Date: Mon Aug 21 2017 - 12:05:01 EST


Implement voltage switch callback (shamelessly copied from sunxi mmc
driver). This allow, with the appropriate tuning function, to use
SD ultra high speed modes.

Reviewed-by: Kevin Hilman <khilman@xxxxxxxxxxxx>
Signed-off-by: Jerome Brunet <jbrunet@xxxxxxxxxxxx>
---
drivers/mmc/host/meson-gx-mmc.c | 23 +++++++++++++++++++++++
1 file changed, 23 insertions(+)

diff --git a/drivers/mmc/host/meson-gx-mmc.c b/drivers/mmc/host/meson-gx-mmc.c
index df1ac96bd0db..3167f561e1a6 100644
--- a/drivers/mmc/host/meson-gx-mmc.c
+++ b/drivers/mmc/host/meson-gx-mmc.c
@@ -1050,6 +1050,28 @@ static int meson_mmc_card_busy(struct mmc_host *mmc)
return !(FIELD_GET(STATUS_DATI, regval) & 0xf);
}

+static int meson_mmc_voltage_switch(struct mmc_host *mmc, struct mmc_ios *ios)
+{
+ /* vqmmc regulator is available */
+ if (!IS_ERR(mmc->supply.vqmmc)) {
+ /*
+ * The usual amlogic setup uses a GPIO to switch from one
+ * regulator to the other. While the voltage ramp up is
+ * pretty fast, care must be taken when switching from 3.3v
+ * to 1.8v. Please make sure the regulator framework is aware
+ * of your own regulator constraints
+ */
+ return mmc_regulator_set_vqmmc(mmc, ios);
+
+ }
+
+ /* no vqmmc regulator, assume fixed regulator at 3/3.3V */
+ if (ios->signal_voltage == MMC_SIGNAL_VOLTAGE_330)
+ return 0;
+
+ return -EINVAL;
+}
+
static const struct mmc_host_ops meson_mmc_ops = {
.request = meson_mmc_request,
.set_ios = meson_mmc_set_ios,
@@ -1058,6 +1080,7 @@ static const struct mmc_host_ops meson_mmc_ops = {
.post_req = meson_mmc_post_req,
.execute_tuning = meson_mmc_execute_tuning,
.card_busy = meson_mmc_card_busy,
+ .start_signal_voltage_switch = meson_mmc_voltage_switch,
};

static int meson_mmc_probe(struct platform_device *pdev)
--
2.9.5