Re: [PATCH 03/14] qcom: mtd: nand: Fixed config error for BCH

[Sricharan R]

Hi Abhishek,

On 6/29/2017 12:45 PM, Abhishek Sahu wrote:
> The configuration for BCH is not correct in the current
> driver so this patch fixed the same.
> 
> Signed-off-by: Abhishek Sahu <absahu@xxxxxxxxxxxxxx>
> ---
>  drivers/mtd/nand/qcom_nandc.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/drivers/mtd/nand/qcom_nandc.c b/drivers/mtd/nand/qcom_nandc.c
> index 520add9..410ee53 100644
> --- a/drivers/mtd/nand/qcom_nandc.c
> +++ b/drivers/mtd/nand/qcom_nandc.c
> @@ -1919,7 +1919,7 @@ static int qcom_nand_host_setup(struct qcom_nand_host *host)
>  				| wide_bus << WIDE_FLASH
>  				| 1 << DEV0_CFG1_ECC_DISABLE;
>  
> -	host->ecc_bch_cfg = host->bch_enabled << ECC_CFG_ECC_DISABLE
> +	host->ecc_bch_cfg = !host->bch_enabled << ECC_CFG_ECC_DISABLE
>  				| 0 << ECC_SW_RESET
>  				| host->cw_data << ECC_NUM_DATA_BYTES
>  				| 1 << ECC_FORCE_CLK_OPEN
> 

 This could be patch #1, so basically all fixes first and then support
 for bam after that.

Regards,
 Sricharan

-- 
"QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation

---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus