Re: [PATCH v9 7/9] coresight: add support for CPU debug module

[Suzuki K Poulose]

On 09/05/17 03:50, Leo Yan wrote:
> Coresight includes debug module and usually the module connects with CPU
> debug logic. ARMv8 architecture reference manual (ARM DDI 0487A.k) has
> description for related info in "Part H: External Debug".
>
> Chapter H7 "The Sample-based Profiling Extension" introduces several
> sampling registers, e.g. we can check program counter value with
> combined CPU exception level, secure state, etc. So this is helpful for
> analysis CPU lockup scenarios, e.g. if one CPU has run into infinite
> loop with IRQ disabled. In this case the CPU cannot switch context and
> handle any interrupt (including IPIs), as the result it cannot handle
> SMP call for stack dump.
>
> This patch is to enable coresight debug module, so firstly this driver
> is to bind apb clock for debug module and this is to ensure the debug
> module can be accessed from program or external debugger. And the driver
> uses sample-based registers for debug purpose, e.g. when system triggers
> panic, the driver will dump program counter and combined context
> registers (EDCIDSR, EDVIDSR); by parsing context registers so can
> quickly get to know CPU secure state, exception level, etc.
>
> Some of the debug module registers are located in CPU power domain, so
> this requires the CPU power domain stays on when access related debug
> registers, but the power management for CPU power domain is quite
> dependent on SoC integration for power management. For the platforms
> which with sane power controller implementations, this driver follows
> the method to set EDPRCR to try to pull the CPU out of low power state
> and then set 'no power down request' bit so the CPU has no chance to
> lose power.
>
> If the SoC has not followed up this design well for power management
> controller, the user should use the command line parameter or sysfs
> to constrain all or partial idle states to ensure the CPU power
> domain is enabled and access coresight CPU debug component safely.
>
> Signed-off-by: Leo Yan <leo.yan@xxxxxxxxxx>

With comments from Mathieu addressed,

Reviewed-by: Suzuki K Poulose <suzuki.poulose@xxxxxxx>