Re: [PATCH net-next] bindings: net: stmmac: add missing note about LPI interrupt

From: Niklas Cassel
Date: Mon Apr 10 2017 - 03:43:27 EST


On 04/07/2017 06:48 PM, Sergei Shtylyov wrote:
> Hello!
>
> On 04/07/2017 05:30 PM, Niklas Cassel wrote:
>
>> From: Niklas Cassel <niklas.cassel@xxxxxxxx>
>>
>> The hardware has a LPI interrupt.
>> There is already code in the stmmac driver to parse and handle the
>> interrupt. However, this information was missing from the DT binding.
>>
>> Signed-off-by: Niklas Cassel <niklas.cassel@xxxxxxxx>
>> ---
>> Documentation/devicetree/bindings/net/stmmac.txt | 8 ++++----
>> 1 file changed, 4 insertions(+), 4 deletions(-)
>>
>> diff --git a/Documentation/devicetree/bindings/net/stmmac.txt b/Documentation/devicetree/bindings/net/stmmac.txt
>> index f652b0c384ce..8977abc266ac 100644
>> --- a/Documentation/devicetree/bindings/net/stmmac.txt
>> +++ b/Documentation/devicetree/bindings/net/stmmac.txt
>> @@ -8,8 +8,8 @@ Required properties:
>> that services interrupts for this device
>> - interrupts: Should contain the STMMAC interrupts
>> - interrupt-names: Should contain the interrupt names "macirq"
>> - "eth_wake_irq" if this interrupt is supported in the "interrupts"
>> - property
>> + "eth_wake_irq" if this interrupt is supported in the "interrupts property
>
> Missed closing quote?

Thanks for pointing it out.
Will send a v2.

>
>> + "eth_lpi" if this interrupt is supported in the "interrupts" property
>> - phy-mode: See ethernet.txt file in the same directory.
>> - snps,reset-gpio gpio number for phy reset.
>> - snps,reset-active-low boolean flag to indicate if phy reset is active low.
> [...]
>
> MBR, Sergei
>