Re: [PATCH v5 21/23] drivers/fsi: Add SCOM FSI client device driver

[Christopher Bostic]

On 4/5/17 11:35 AM, Randy Dunlap wrote:
> On 04/04/17 19:06, Christopher Bostic wrote:
> > From: Chris Bostic <cbostic@xxxxxxxxxxxxxxxxxx>
> >
> > Create a simple SCOM engine device driver that reads and writes
> > its control registers via an FSI bus.
> >
> > Includes changes from Edward A. James <eajames@xxxxxxxxxx>.
> >
> > Signed-off-by: Chris Bostic <cbostic@xxxxxxxxxxxxxxxxxx>
> > Signed-off-by: Joel Stanley <joel@xxxxxxxxx>
> > Signed-off-by: Edward A. James <eajames@xxxxxxxxxx>
> > Signed-off-by: Jeremy Kerr <jk@xxxxxxxxxx>
> > ---
> >   drivers/fsi/Kconfig    |   6 ++
> >   drivers/fsi/Makefile   |   1 +
> >   drivers/fsi/fsi-scom.c | 263 +++++++++++++++++++++++++++++++++++++++++++++++++
> >   3 files changed, 270 insertions(+)
> >   create mode 100644 drivers/fsi/fsi-scom.c
> >
> > diff --git a/drivers/fsi/Kconfig b/drivers/fsi/Kconfig
> > index 9cf8345..0fa265c 100644
> > --- a/drivers/fsi/Kconfig
> > +++ b/drivers/fsi/Kconfig
> > @@ -18,6 +18,12 @@ config FSI_MASTER_GPIO
> >   	---help---
> >   	This option enables a FSI master driver using GPIO lines.
> >   
> > +config FSI_SCOM
> > +	tristate "SCOM FSI client device driver"
> > +	depends on FSI
> depends on FSI is redundant.

Will correct.

Thanks,
Chris
> > +	---help---
> > +	This option enables an FSI based SCOM device driver.
> > +
> >   endif
> >