Re: deadlock in synchronize_srcu() in debugfs?

From: Paul E. McKenney
Date: Fri Mar 24 2017 - 16:20:56 EST


On Fri, Mar 24, 2017 at 12:33:22PM -0700, Paul E. McKenney wrote:
> On Fri, Mar 24, 2017 at 07:51:47PM +0100, Johannes Berg wrote:
> >
> > > Yes.  CPU2 has a pre-existing reader that CPU1's synchronize_srcu()
> > > must wait for.  But CPU2's reader cannot end until CPU1 releases
> > > its lock, which it cannot do until after CPU2's reader ends.  Thus,
> > > as you say, deadlock.
> > >
> > > The rule is that if you are within any kind of RCU read-side critical
> > > section, you cannot directly or indirectly wait for a grace period
> > > from that same RCU flavor.
> >
> > Right. This is indirect then, in a way.
>
> Agreed, in a way. ;-)
>
> > > There are some challenges, though.  This is OK:
> > >
> > > CPU1 CPU2
> > > i = srcu_read_lock(&mysrcu); mutex_lock(&my_lock);
> > > mutex_lock(&my_lock); i = srcu_read_lock(&mysrcu);
> > > srcu_read_unlock(&mysrcu, i); mutex_unlock(&my_lock);
> > > mutex_unlock(&my_lock); srcu_read_unlock(&mysrcu, i);
> > >
> > > CPU3
> > > synchronize_srcu(&mylock);
> > >
> > > This could be a deadlock for reader-writer locking, but not for SRCU.
> >
> > Hmm, yes, that's a good point. If srcu_read_lock() was read_lock, and
> > synchronize_srcu() was write_lock(), then the write_lock() could stop
> > CPU2's read_lock() from acquiring the lock, and thus cause a deadlock.
>
> Yes.
>
> > However, I'm not convinced that lockdep handles reader/writer locks
> > correctly to start with, right now, since it *didn't* actually trigger
> > any warnings when I annotated SRCU as a reader/writer lock.
>
> I haven't looked into lockdep enough to know either way.
>
> > > This is also OK:
> > > CPU1 CPU2
> > > i = srcu_read_lock(&mysrcu); mutex_lock(&my_lock);
> > > mutex_lock(&my_lock); synchronize_srcu(&yoursrc
> > u);
> > > srcu_read_unlock(&mysrcu, i); mutex_unlock(&my_lock);
> > > mutex_unlock(&my_lock);
> > >
> > > Here CPU1's read-side critical sections are for mysrcu, which is
> > > independent of CPU2's grace period for yoursrcu.
> >
> > Right, but that's already covered by having separate a lockdep_map for
> > each SRCU subsystem (mysrcu, yoursrcu).
>
> I hope so, but haven't proved that this would work in all possible cases.
>
> > > So you could flag any lockdep cycle that contained a reader and a
> > > synchronous grace period for the same flavor of RCU, where for SRCU
> > > the identity of the srcu_struct structure is part of the flavor.
> >
> > Right. Basically, I think SRCU should be like a reader/writer lock
> > (perhaps fixed to work right). The only difference seems to be the
> > scenario you outlined above (first of the two)?
> >
> > Actually, given the scenario above, for lockdep purposes the
> > reader/writer lock is actually the same as a recursive lock, I guess?
>
> Except that a recursive reader/writer lock can still have deadlocks
> involving the outermost reader that would not be deadlocks for the
> equivalent SRCU scenarios.
>
> > You outlined a scenario in which the reader gets blocked due to a
> > writer (CPU3 doing a write_lock()) so the reader can still participate
> > in a deadlock cycle since it can - without any other locks being held
> > by CPU3 that participate - cause a deadlock between CPU1 and CPU2 here.
> > For lockdep then, even seeing the CPU1 and CPU2 scenarios should be
> > sufficient to flag a deadlock (*).
>
> Might this be one of the reasons why lockdep has problems with
> reader-writer locks?
>
> > This part then isn't true for SRCU, because there forward progress will
> > still be made. So for SRCU, the "reader" side really needs to be
> > connected with a "writer" side to form a deadlock cycle, unlike for a
> > reader/writer lock.
>
> Yes, for SRCU, srcu_read_lock() itself never blocks, so it never
> participates directly in a deadlock cycle. It has to be the case
> that something within the SRCU read-side critical section blocks
> and takes its place in the deadlock cycle.
>
> Then again, if you didn't have something blocking within your SRCU
> read-side critical section, why would you be using SRCU instead of
> just plain RCU? ;-)
>
> > johannes
> >
> > (*) technically only after checking that write_lock() is ever used, but
> > ... seems reasonable enough to assume that it will be used, since why
> > would anyone ever use a reader/writer lock if there are only readers?
> > That's a no-op.
>
> Makes sense to me! The only reasons I can come up with are things like
> shutting lockdep up when it wants a given lock read-held or some such.

And I cannot resist adding this one:

CPU 1 CPU 2
i = srcu_read_lock(&s1); mutex_lock(&l1);
mutex_lock(&l1); synchronize_srcu(&s2);
mutex_unlock(&l1); mutex_unlock(&l1);
srcu_read_unlock(&s1, i);

CPU 3 CPU 4
i = srcu_read_lock(&s2); mutex_lock(&l2);
mutex_lock(&l2); synchronize_srcu(&s1);
mutex_unlock(&l2); mutex_unlock(&l2);
srcu_read_unlock(&s2, i);

Removing the SRCU statements from any of these CPU would break the
deadlock. This can be easily extended to a deadlock cycle involving
any number of srcu_struct structures.

But this would still be a cycle involving an srcu_read_lock() and a
synchronize_srcu() on the same srcu_struct, which is reassuring.

Thanx, Paul