Hi,Add linux-next specific files for 20161224
On 12/29/2016 09:55 PM, ayaka wrote:
[ 5.849733] rk_gmac-dwmac ff290000.ethernet (unnamed net_device) (uninitialized): Enable RX Mitigation via HW Watchdog TimerPlz..Don't put the comment on the top.
[ 5.944512] mmc_host mmc1: Bus speed (slot 0) = 50000000Hz (slot req 50000000Hz, actual 50000000HZ div = 0)
[ 5.958249] mmc1: new ultra high speed DDR50 SDIO card at address 0001
[ 6.294548] dwmmc_rockchip ff0f0000.dwmmc: Successfully tuned phase to 177
[ 6.301591] mmc2: new HS200 MMC card at address 0001
[ 6.306758] mmc_host mmc0: Bus speed (slot 0) = 300000Hz (slot req 300000Hz, actual 300000HZ div = 0)
[ 6.316830] mmcblk2: mmc2:0001 AGND3R 14.6 GiB
[ 6.321881] mmcblk2boot0: mmc2:0001 AGND3R partition 1 4.00 MiB
[ 6.328331] mmcblk2boot1: mmc2:0001 AGND3R partition 2 4.00 MiB
[ 6.334792] mmcblk2rpmb: mmc2:0001 AGND3R partition 3 4.00 MiB
[ 6.344295] mmcblk2: p1 p2 p3 p4 p5 p6 p7
[ 6.469892] mmc_host mmc0: Bus speed (slot 0) = 200000Hz (slot req 200000Hz, actual 200000HZ div = 0)
[ 6.621888] mmc_host mmc0: Bus speed (slot 0) = 187500Hz (slot req 100000Hz, actual 93750HZ div = 1)
[ 6.917883] libphy: stmmac: probed
[ 6.921319] rk_gmac-dwmac ff290000.ethernet eth0: PHY ID 001cc915 at 0 IRQ POLL (stmmac-0:00) active
[ 6.930476] rk_gmac-dwmac ff290000.ethernet eth0: PHY ID 001cc915 at 2 IRQ POLL (stmmac-0:02)
[ 6.939757] input: gpio-keys as /devices/platform/gpio-keys/input/input0
[ 6.946937] rtc-hym8563 0-0051: no valid clock/calendar values available
[ 6.953694] rtc-hym8563 0-0051: hctosys: unable to read the hardware clock
[ 6.961262] vcc_sd: disabling
[ 6.964275] dovdd_1v8: disabling
[ 6.967527] dvdd_1v2: disabling
[ 6.971006] vdd10_lcd: disabling
[ 6.974701] vcc18_lcd: disabling
[ 6.978467] ttyS2 - failed to request DMA
[ 7.101883] mmc_host mmc0: Bus speed (slot 0) = 400000Hz (slot req 400000Hz, actual 400000HZ div = 0)
[ 7.253874] mmc_host mmc0: Bus speed (slot 0) = 300000Hz (slot req 300000Hz, actual 300000HZ div = 0)
[ 7.405883] mmc_host mmc0: Bus speed (slot 0) = 200000Hz (slot req 200000Hz, actual 200000HZ div = 0)
[ 7.557885] mmc_host mmc0: Bus speed (slot 0) = 187500Hz (slot req 100000Hz, actual 93750HZ div = 1)
[ 8.037872] mmc_host mmc0: Bus speed (slot 0) = 400000Hz (slot req 400000Hz, actual 400000HZ div = 0)
[ 8.189877] mmc_host mmc0: Bus speed (slot 0) = 300000Hz (slot req 300000Hz, actual 300000HZ div = 0)
[ 8.341881] mmc_host mmc0: Bus speed (slot 0) = 200000Hz (slot req 200000Hz, actual 200000HZ div = 0)
[ 8.493884] mmc_host mmc0: Bus speed (slot 0) = 187500Hz (slot req 100000Hz, actual 93750HZ div = 1)
[ 8.973871] mmc_host mmc0: Bus speed (slot 0) = 400000Hz (slot req 400000Hz, actual 400000HZ div = 0)
[ 9.125876] mmc_host mmc0: Bus speed (slot 0) = 300000Hz (slot req 300000Hz, actual 300000HZ div = 0)
[ 9.277884] mmc_host mmc0: Bus speed (slot 0) = 200000Hz (slot req 200000Hz, actual 200000HZ div = 0)
[ 9.429882] mmc_host mmc0: Bus speed (slot 0) = 187500Hz (slot req 100000Hz, actual 93750HZ div = 1)
looping here
If I revert that patch, there are still lots of Bus speed messages, but finally would enter into system.
Which kernel did you use?
On 12/29/2016 06:25 PM, Randy Li wrote:
On 12/29/2016 03:25 PM, Shawn Lin wrote:
On 2016/12/29 15:13, Jaehoon Chung wrote:Sorry, XZY has asked me about this in the morning and I answer him that I would give a feedback at home, so I didn't notice this mail.
On 12/29/2016 12:02 PM, Jaehoon Chung wrote:Hrmm.....as that patchset was tested based on rk3288 and rk3368, so I
Hi Randy,To Shawn,
On 12/29/2016 12:34 AM, Randy Li wrote:
This reverts commit f90142683f04bcb0729bf0df67a5e29562b725b9.Could you explain in more detail?
It is reported that making RK3288 can't boot from eMMC/MMC.
As you mentioned, this patch is making that RK3288 can't boot..then why?
Good way should be that finds the main reason and fixes it.
Not just revert.
Could you check this? If you have rk3288..
If it's not working fine, it needs to revert this patch until finding
the problem.
need to know which board Randy are using now and could you share some
The board is Firefly reload. but the reporter told me that Firefly release also have the same problem.
log?
I will have a look at it.
Best Regards,
Jaehoon Chung
Best Regards,
Jaehoon Chung
Signed-off-by: Randy Li <ayaka@xxxxxxxxxxx>--
---
drivers/mmc/host/dw_mmc-rockchip.c | 41
+++-----------------------------------
1 file changed, 3 insertions(+), 38 deletions(-)
diff --git a/drivers/mmc/host/dw_mmc-rockchip.c
b/drivers/mmc/host/dw_mmc-rockchip.c
index 9a46e46..3189234 100644
--- a/drivers/mmc/host/dw_mmc-rockchip.c
+++ b/drivers/mmc/host/dw_mmc-rockchip.c
@@ -14,7 +14,6 @@
#include <linux/mmc/dw_mmc.h>
#include <linux/of_address.h>
#include <linux/mmc/slot-gpio.h>
-#include <linux/pm_runtime.h>
#include <linux/slab.h>
#include "dw_mmc.h"
@@ -327,7 +326,6 @@ static int dw_mci_rockchip_probe(struct
platform_device *pdev)
{
const struct dw_mci_drv_data *drv_data;
const struct of_device_id *match;
- int ret;
if (!pdev->dev.of_node)
return -ENODEV;
@@ -335,49 +333,16 @@ static int dw_mci_rockchip_probe(struct
platform_device *pdev)
match = of_match_node(dw_mci_rockchip_match, pdev->dev.of_node);
drv_data = match->data;
- pm_runtime_get_noresume(&pdev->dev);
- pm_runtime_set_active(&pdev->dev);
- pm_runtime_enable(&pdev->dev);
- pm_runtime_set_autosuspend_delay(&pdev->dev, 50);
- pm_runtime_use_autosuspend(&pdev->dev);
-
- ret = dw_mci_pltfm_register(pdev, drv_data);
- if (ret) {
- pm_runtime_disable(&pdev->dev);
- pm_runtime_set_suspended(&pdev->dev);
- pm_runtime_put_noidle(&pdev->dev);
- return ret;
- }
-
- pm_runtime_put_autosuspend(&pdev->dev);
-
- return 0;
+ return dw_mci_pltfm_register(pdev, drv_data);
}
-static int dw_mci_rockchip_remove(struct platform_device *pdev)
-{
- pm_runtime_get_sync(&pdev->dev);
- pm_runtime_disable(&pdev->dev);
- pm_runtime_put_noidle(&pdev->dev);
-
- return dw_mci_pltfm_remove(pdev);
-}
-
-static const struct dev_pm_ops dw_mci_rockchip_dev_pm_ops = {
- SET_SYSTEM_SLEEP_PM_OPS(pm_runtime_force_suspend,
- pm_runtime_force_resume)
- SET_RUNTIME_PM_OPS(dw_mci_runtime_suspend,
- dw_mci_runtime_resume,
- NULL)
-};
-
static struct platform_driver dw_mci_rockchip_pltfm_driver = {
.probe = dw_mci_rockchip_probe,
- .remove = dw_mci_rockchip_remove,
+ .remove = dw_mci_pltfm_remove,
.driver = {
.name = "dwmmc_rockchip",
.of_match_table = dw_mci_rockchip_match,
- .pm = &dw_mci_rockchip_dev_pm_ops,
+ .pm = &dw_mci_pltfm_pmops,
},
};
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
.