[PATCH v5 3/6] regulator: core: Don't skip set_voltage_time when ramp delay disabled

From: Matthias Kaehlcke
Date: Wed Sep 14 2016 - 12:54:41 EST


The current code assumes that only the ramp_delay is used to determine
the time needed for the voltage to stabilize. This may be true for the
calculation done by regulator_set_voltage_time_sel(), however regulators
can implement their own set_voltage_time_sel() op which would be skipped
if no ramp delay is specified. Remove the check in
_regulator_do_set_voltage(), the functions calculating the ramp delay
return 0 anyway when the ramp delay is not configured.

Signed-off-by: Matthias Kaehlcke <mka@xxxxxxxxxxxx>
---
Changes in v5:
- This patch is new for v5.

drivers/regulator/core.c | 8 ++------
1 file changed, 2 insertions(+), 6 deletions(-)

diff --git a/drivers/regulator/core.c b/drivers/regulator/core.c
index b0076cc..df3028b 100644
--- a/drivers/regulator/core.c
+++ b/drivers/regulator/core.c
@@ -2804,9 +2804,7 @@ static int _regulator_do_set_voltage(struct regulator_dev *rdev,
goto out;

/* Call set_voltage_time_sel if successfully obtained old_selector */
- if (!rdev->constraints->ramp_disable && old_selector >= 0
- && old_selector != selector) {
-
+ if (!old_selector >= 0 && old_selector != selector) {
delay = ops->set_voltage_time_sel(rdev,
old_selector, selector);
if (delay < 0) {
@@ -3051,10 +3049,8 @@ int regulator_set_voltage_time_sel(struct regulator_dev *rdev,
else if (rdev->desc->ramp_delay)
ramp_delay = rdev->desc->ramp_delay;

- if (ramp_delay == 0) {
- rdev_warn(rdev, "ramp_delay not set\n");
+ if (ramp_delay == 0)
return 0;
- }

/* sanity check */
if (!rdev->desc->ops->list_voltage)
--
2.8.0.rc3.226.g39d4020