[PATCH] ath10k: Spelling and miscellaneous neatening

From: Joe Perches
Date: Mon Aug 29 2016 - 13:06:23 EST

Next message: Josh Poimboeuf: "[PATCH v2] mm/usercopy: get rid of CONFIG_DEBUG_STRICT_USER_COPY_CHECKS"
Previous message: Jaegeuk Kim: "Re: [PATCH 2/2] f2fs: add roll-forward recovery process for encrypted dentry"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Correct some trivial comment typos.
Remove unnecessary parentheses in a long line.
Convert a return; before the end of a void function definition to just ;

Signed-off-by: Joe Perches <joe@xxxxxxxxxxx>
---
drivers/net/wireless/ath/ath10k/ce.c | 2 +-
drivers/net/wireless/ath/ath10k/core.c | 2 +-
drivers/net/wireless/ath/ath10k/htt.h | 8 ++++----
drivers/net/wireless/ath/ath10k/hw.c | 2 +-
drivers/net/wireless/ath/ath10k/hw.h | 2 +-
drivers/net/wireless/ath/ath10k/targaddrs.h | 2 +-
drivers/net/wireless/ath/ath10k/wmi.h | 24 ++++++++++++------------
7 files changed, 21 insertions(+), 21 deletions(-)

diff --git a/drivers/net/wireless/ath/ath10k/ce.c b/drivers/net/wireless/ath/ath10k/ce.c
index 9fb8d74..cea9684 100644
--- a/drivers/net/wireless/ath/ath10k/ce.c
+++ b/drivers/net/wireless/ath/ath10k/ce.c
@@ -39,7 +39,7 @@
* chooses what to send (buffer address, length). The destination
* side keeps a supply of "anonymous receive buffers" available and
* it handles incoming data as it arrives (when the destination
- * recieves an interrupt).
+ * receives an interrupt).
*
* The sender may send a simple buffer (address/length) or it may
* send a small list of buffers. When a small list is sent, hardware
diff --git a/drivers/net/wireless/ath/ath10k/core.c b/drivers/net/wireless/ath/ath10k/core.c
index e889829..1e8147a 100644
--- a/drivers/net/wireless/ath/ath10k/core.c
+++ b/drivers/net/wireless/ath/ath10k/core.c
@@ -2118,7 +2118,7 @@ err:
/* TODO: It's probably a good idea to release device from the driver
* but calling device_release_driver() here will cause a deadlock.
*/
- return;
+ ;
}

int ath10k_core_register(struct ath10k *ar, u32 chip_id)
diff --git a/drivers/net/wireless/ath/ath10k/htt.h b/drivers/net/wireless/ath/ath10k/htt.h
index 430a83e..cedb4e8 100644
--- a/drivers/net/wireless/ath/ath10k/htt.h
+++ b/drivers/net/wireless/ath/ath10k/htt.h
@@ -595,7 +595,7 @@ enum htt_rx_mpdu_status {
/* only accept EAPOL frames */
HTT_RX_IND_MPDU_STATUS_UNAUTH_PEER,
HTT_RX_IND_MPDU_STATUS_OUT_OF_SYNC,
- /* Non-data in promiscous mode */
+ /* Non-data in promiscuous mode */
HTT_RX_IND_MPDU_STATUS_MGMT_CTRL,
HTT_RX_IND_MPDU_STATUS_TKIP_MIC_ERR,
HTT_RX_IND_MPDU_STATUS_DECRYPT_ERR,
@@ -900,7 +900,7 @@ struct htt_rx_in_ord_ind {
* Purpose: indicate how many 32-bit integers follow the message header
* - NUM_CHARS
* Bits 31:16
- * Purpose: indicate how many 8-bit charaters follow the series of integers
+ * Purpose: indicate how many 8-bit characters follow the series of integers
*/
struct htt_rx_test {
u8 num_ints;
@@ -1042,10 +1042,10 @@ struct htt_dbg_stats_wal_tx_stats {
/* illegal rate phy errors */
__le32 illgl_rate_phy_err;

- /* wal pdev continous xretry */
+ /* wal pdev continuous xretry */
__le32 pdev_cont_xretry;

- /* wal pdev continous xretry */
+ /* wal pdev continuous xretry */
__le32 pdev_tx_timeout;

/* wal pdev resets */
diff --git a/drivers/net/wireless/ath/ath10k/hw.c b/drivers/net/wireless/ath/ath10k/hw.c
index f903d46..ed917cb 100644
--- a/drivers/net/wireless/ath/ath10k/hw.c
+++ b/drivers/net/wireless/ath/ath10k/hw.c
@@ -85,7 +85,7 @@ const struct ath10k_hw_regs qca99x0_regs = {
.ce7_base_address = 0x0004bc00,
/* Note: qca99x0 supports upto 12 Copy Engines. Other than address of
* CE0 and CE1 no other copy engine is directly referred in the code.
- * It is not really neccessary to assign address for newly supported
+ * It is not really necessary to assign address for newly supported
* CEs in this address table.
* Copy Engine Address
* CE8 0x0004c000
diff --git a/drivers/net/wireless/ath/ath10k/hw.h b/drivers/net/wireless/ath/ath10k/hw.h
index e014cd7..93ca128 100644
--- a/drivers/net/wireless/ath/ath10k/hw.h
+++ b/drivers/net/wireless/ath/ath10k/hw.h
@@ -284,7 +284,7 @@ void ath10k_hw_fill_survey_time(struct ath10k *ar, struct survey_info *survey,
#define QCA_REV_9377(ar) ((ar)->hw_rev == ATH10K_HW_QCA9377)
#define QCA_REV_40XX(ar) ((ar)->hw_rev == ATH10K_HW_QCA4019)

-/* Known pecularities:
+/* Known peculiarities:
* - raw appears in nwifi decap, raw and nwifi appear in ethernet decap
* - raw have FCS, nwifi doesn't
* - ethernet frames have 802.11 header decapped and parts (base hdr, cipher
diff --git a/drivers/net/wireless/ath/ath10k/targaddrs.h b/drivers/net/wireless/ath/ath10k/targaddrs.h
index aaf53a8..a47cab4 100644
--- a/drivers/net/wireless/ath/ath10k/targaddrs.h
+++ b/drivers/net/wireless/ath/ath10k/targaddrs.h
@@ -405,7 +405,7 @@ Fw Mode/SubMode Mask
* 1. target firmware would check magic number and if it's a match, firmware
* would consider the bits[0:15] are valid and base on that to calculate
* the end of DRAM. Early allocation would be located at that area and
- * may be reclaimed when necesary
+ * may be reclaimed when necessary
* 2. if no magic number is found, early allocation would happen at "_end"
* symbol of ROM which is located before the app-data and might NOT be
* re-claimable. If this is adopted, link script should keep this in
diff --git a/drivers/net/wireless/ath/ath10k/wmi.h b/drivers/net/wireless/ath/ath10k/wmi.h
index 3ef4688..452790e 100644
--- a/drivers/net/wireless/ath/ath10k/wmi.h
+++ b/drivers/net/wireless/ath/ath10k/wmi.h
@@ -55,7 +55,7 @@
* type.
*
* 6. Comment each parameter part of the WMI command/event structure by
- * using the 2 stars at the begining of C comment instead of one star to
+ * using the 2 stars at the beginning of C comment instead of one star to
* enable HTML document generation using Doxygen.
*
*/
@@ -2082,7 +2082,7 @@ struct wmi_resource_config {
* In offload mode target supports features like WOW, chatter and
* other protocol offloads. In order to support them some
* functionalities like reorder buffering, PN checking need to be
- * done in target. This determines maximum number of peers suported
+ * done in target. This determines maximum number of peers supported
* by target in offload mode
*/
__le32 num_offload_peers;
@@ -2263,7 +2263,7 @@ struct wmi_resource_config {
* Max. number of Tx fragments per MSDU
* This parameter controls the max number of Tx fragments per MSDU.
* This is sent by the target as part of the WMI_SERVICE_READY event
- * and is overriden by the OS shim as required.
+ * and is overridden by the OS shim as required.
*/
__le32 max_frag_entries;
} __packed;
@@ -2445,7 +2445,7 @@ struct wmi_resource_config_10x {
* Max. number of Tx fragments per MSDU
* This parameter controls the max number of Tx fragments per MSDU.
* This is sent by the target as part of the WMI_SERVICE_READY event
- * and is overriden by the OS shim as required.
+ * and is overridden by the OS shim as required.
*/
__le32 max_frag_entries;
} __packed;
@@ -2739,7 +2739,7 @@ struct wmi_init_cmd {
struct wmi_host_mem_chunks mem_chunks;
} __packed;

-/* _10x stucture is from 10.X FW API */
+/* _10x structure is from 10.X FW API */
struct wmi_init_cmd_10x {
struct wmi_resource_config_10x resource_config;
struct wmi_host_mem_chunks mem_chunks;
@@ -3962,7 +3962,7 @@ struct wmi_pdev_stats_tx {
/* illegal rate phy errors */
__le32 illgl_rate_phy_err;

- /* wal pdev continous xretry */
+ /* wal pdev continuous xretry */
__le32 pdev_cont_xretry;

/* wal pdev continous xretry */
@@ -4456,9 +4456,9 @@ struct wmi_vdev_start_request_cmd {
__le32 flags;
/* ssid field. Only valid for AP/GO/IBSS/BTAmp VDEV type. */
struct wmi_ssid ssid;
- /* beacon/probe reponse xmit rate. Applicable for SoftAP. */
+ /* beacon/probe response xmit rate. Applicable for SoftAP. */
__le32 bcn_tx_rate;
- /* beacon/probe reponse xmit power. Applicable for SoftAP. */
+ /* beacon/probe response xmit power. Applicable for SoftAP. */
__le32 bcn_tx_power;
/* number of p2p NOA descriptor(s) from scan entry */
__le32 num_noa_descriptors;
@@ -4686,7 +4686,7 @@ enum wmi_vdev_param {
WMI_VDEV_PARAM_BEACON_INTERVAL,
/* Listen interval in TUs */
WMI_VDEV_PARAM_LISTEN_INTERVAL,
- /* muticast rate in Mbps */
+ /* multicast rate in Mbps */
WMI_VDEV_PARAM_MULTICAST_RATE,
/* management frame rate in Mbps */
WMI_VDEV_PARAM_MGMT_TX_RATE,
@@ -4817,7 +4817,7 @@ enum wmi_10x_vdev_param {
WMI_10X_VDEV_PARAM_BEACON_INTERVAL,
/* Listen interval in TUs */
WMI_10X_VDEV_PARAM_LISTEN_INTERVAL,
- /* muticast rate in Mbps */
+ /* multicast rate in Mbps */
WMI_10X_VDEV_PARAM_MULTICAST_RATE,
/* management frame rate in Mbps */
WMI_10X_VDEV_PARAM_MGMT_TX_RATE,
@@ -5062,7 +5062,7 @@ struct wmi_vdev_simple_event {
} __packed;

/* VDEV start response status codes */
-/* VDEV succesfully started */
+/* VDEV successfully started */
#define WMI_INIFIED_VDEV_START_RESPONSE_STATUS_SUCCESS 0x0

/* requested VDEV not found */
@@ -5378,7 +5378,7 @@ enum wmi_sta_ps_param_pspoll_count {
#define WMI_UAPSD_AC_TYPE_TRIG 1

#define WMI_UAPSD_AC_BIT_MASK(ac, type) \
- ((type == WMI_UAPSD_AC_TYPE_DELI) ? (1 << (ac << 1)) : (1 << ((ac << 1) + 1)))
+ (type == WMI_UAPSD_AC_TYPE_DELI ? 1 << (ac << 1) : 1 << ((ac << 1) + 1))

enum wmi_sta_ps_param_uapsd {
WMI_STA_PS_UAPSD_AC0_DELIVERY_EN = (1 << 0),
--
2.8.0.rc4.16.g56331f8

Next message: Josh Poimboeuf: "[PATCH v2] mm/usercopy: get rid of CONFIG_DEBUG_STRICT_USER_COPY_CHECKS"
Previous message: Jaegeuk Kim: "Re: [PATCH 2/2] f2fs: add roll-forward recovery process for encrypted dentry"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]