[for-next][PATCH 10/12] tracing: Expose CPU physical addresses (resource values) for PCI devices

From: Steven Rostedt
Date: Sun Jul 03 2016 - 16:34:26 EST


From: Bjorn Helgaas <bhelgaas@xxxxxxxxxx>

Previously, mmio_print_pcidev() put "user" addresses in the trace buffer.
On most architectures, these are the same as CPU physical addresses, but on
microblaze, mips, powerpc, and sparc, they may be something else, typically
a raw BAR value (a bus address as opposed to a CPU address).

Always expose the CPU physical address to avoid this arch-dependent
behavior.

This change should have no user-visible effect because this file currently
depends on CONFIG_HAVE_MMIOTRACE_SUPPORT, which is only defined for x86,
and pci_resource_to_user() is a no-op on x86.

Link: http://lkml.kernel.org/r/20160511190657.5898.4248.stgit@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

Signed-off-by: Bjorn Helgaas <bhelgaas@xxxxxxxxxx>
Signed-off-by: Steven Rostedt <rostedt@xxxxxxxxxxx>
---
kernel/trace/trace_mmiotrace.c | 10 +++-------
1 file changed, 3 insertions(+), 7 deletions(-)

diff --git a/kernel/trace/trace_mmiotrace.c b/kernel/trace/trace_mmiotrace.c
index 68f376ca6d3f..cd7480d0a201 100644
--- a/kernel/trace/trace_mmiotrace.c
+++ b/kernel/trace/trace_mmiotrace.c
@@ -68,19 +68,15 @@ static void mmio_print_pcidev(struct trace_seq *s, const struct pci_dev *dev)
trace_seq_printf(s, "PCIDEV %02x%02x %04x%04x %x",
dev->bus->number, dev->devfn,
dev->vendor, dev->device, dev->irq);
- /*
- * XXX: is pci_resource_to_user() appropriate, since we are
- * supposed to interpret the __ioremap() phys_addr argument based on
- * these printed values?
- */
for (i = 0; i < 7; i++) {
- pci_resource_to_user(dev, i, &dev->resource[i], &start, &end);
+ start = dev->resource[i].start;
trace_seq_printf(s, " %llx",
(unsigned long long)(start |
(dev->resource[i].flags & PCI_REGION_FLAG_MASK)));
}
for (i = 0; i < 7; i++) {
- pci_resource_to_user(dev, i, &dev->resource[i], &start, &end);
+ start = dev->resource[i].start;
+ end = dev->resource[i].end;
trace_seq_printf(s, " %llx",
dev->resource[i].start < dev->resource[i].end ?
(unsigned long long)(end - start) + 1 : 0);
--
2.8.1