Re: [PATCH v7 4/4] i2c: tegra: proper handling of error cases

From: Wolfram Sang
Date: Wed May 11 2016 - 10:48:10 EST


On Mon, Apr 25, 2016 at 07:08:39PM +0530, Shardar Shariff Md wrote:
> To summarize the issue observed in error cases:
>
> SW Flow: For i2c message transfer, packet header and data payload is
> posted and then required error/packet completion interrupts are enabled
> later.
>
> HW flow: HW process the packet just after packet header is posted, if
> ARB lost/NACK error occurs (SW will not handle immediately when error
> happens as error interrupts are not enabled at this point). HW assumes
> error is acknowledged and clears current data in FIFO, But SW here posts
> the remaining data payload which still stays in FIFO as stale data
> (data without packet header).
>
> Now once the interrupts are enabled, SW handles ARB lost/NACK error by
> clearing the ARB lost/NACK interrupt. Now HW assumes that SW attended
> the error and will parse/process stale data (data without packet header)
> present in FIFO which causes invalid NACK errors.
>
> Fix: Enable the error interrupts before posting the packet into FIFO
> which make sure HW to not clear the fifo. Also disable the packet mode
> before acknowledging errors (ARB lost/NACK error) to not process any
> stale data. As error interrupts are enabled before posting the packet
> header use spinlock to avoid preempting.
>
> Signed-off-by: Shardar Shariff Md <smohammed@xxxxxxxxxx>
>
> ---
> Changes in v2:
> - Align the commit message to 72 characters per line.
> - Removing unnecessary paranthesis.
> - Handle error in isr
>
> Changes in v3:
> - Printing error if tegra_i2c_disable_packet_mode() fails
> is already present and handling error is not taken cared
> in ISR which was done in v2 but keeping return error in
> *wait_for_config_load() as its used in tegra_i2c_init()
> ---
> drivers/i2c/busses/i2c-tegra.c | 28 ++++++++++++++++++++++++++--
> 1 file changed, 26 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/i2c/busses/i2c-tegra.c b/drivers/i2c/busses/i2c-tegra.c
> index 8d49995..1181bbf 100644
> --- a/drivers/i2c/busses/i2c-tegra.c
> +++ b/drivers/i2c/busses/i2c-tegra.c
> @@ -194,6 +194,7 @@ struct tegra_i2c_dev {
> u16 clk_divisor_non_hs_mode;
> bool is_suspended;
> bool is_multimaster_mode;
> + spinlock_t xfer_lock;

This lock needs a description. The sentence from above is a good
template: "As error interrupts are enabled before posting the packet
header use spinlock to avoid preempting.".

Patches 3+4 look good otherwise but need to be rebased on modified
patch 2.

Thanks,

Wolfram

Attachment: signature.asc
Description: PGP signature