Re: [1/2] bcma: fix building without OF_IRQ

[Arnd Bergmann]

On Thursday 24 March 2016 15:53:14 Kalle Valo wrote:
> Arnd Bergmann <arnd@xxxxxxxx> writes:
> 
> > On Wednesday 23 March 2016 15:52:43 Kalle Valo wrote:
> >> > The bcma driver core can be built with or without DT support, but
> >> > it fails to build when CONFIG_OF=y and CONFIG_OF_IRQ=n, which
> >> > can happen on platforms that do not support IRQ domains.
> >> > 
> >> > ERROR: "irq_create_of_mapping" [drivers/bcma/bcma.ko] undefined!
> >> > ERROR: "of_irq_parse_raw" [drivers/bcma/bcma.ko] undefined!
> >> > ERROR: "of_irq_parse_one" [drivers/bcma/bcma.ko] undefined!
> >> > 
> >> > This adds another compile-time check for OF_IRQ, but also
> >> > gets rid of now unneeded #ifdef checks: Using the simpler
> >> > IS_ENABLED() check for OF_IRQ also covers the case of not
> >> > having CONFIG_OF enabled. The check for CONFIG_OF_ADDRESS
> >> > was added to allow building on architectures without
> >> > OF_ADDRESS, but that has been addressed already in
> >> > b1d06b60e90c ("of: Provide static inline function for
> >> > of_translate_address if needed").
> >> > 
> >> > Signed-off-by: Arnd Bergmann <arnd@xxxxxxxx>
> >> 
> >> Thanks, applied to wireless-drivers.git.
> >> 
> >
> > Thanks! I see you have applied patch 1/2 but not patch 2/2.
> >
> > As mentioned in the comment for patch 2, it should be tested
> > better, but I want to make sure that someone still has it
> > on their radar.
> 
> Just to avoid any confusions I assume you are talking about this patch:
> 
> [v2] bcma: use of_dma_configure() to set initial dma mask
> https://patchwork.kernel.org/patch/8608751/

Correct.

> It's on my patchwork queue and I'm planning to apply it to
> wireless-drivers-next once it opens again.

Ok, sounds good.

	Arnd