Re: [RFC 3/3] CMDQ: Mediatek CMDQ driver

From: Horng-Shyang Liao
Date: Fri Feb 26 2016 - 04:01:05 EST


On Wed, 2016-02-03 at 14:40 +0800, Daniel Kurtz wrote:
> > Hi Dan,
> >
> > Thanks for your comment.
> > This solution looks good to me.
> > I will change it as your suggestion.
> >
> > But, I have a question about 'mask out the provided *device virtual*
> > address'.
> > Are lower 16-bits (or 24-bits for JUMP op) of device virtual address the
> > same as device physical address?
>
> I'm not sure. But I doubt it we can rely on this.
> My guess would be that the ioremap only preserves the lower 12 bits
> (4k page size).
>
> > If not, we still need to pass in physical address into CMDQ driver.
>
> Or, instead of the iommu/slot approach, we can just provide a
> registration function for the gce driver.
> Each gce consumer could then have a simple gce node, with no slot/address:
>
> mediatek,gce = <&gce>;
>
> Then on probe, the gce consumer could pass in its (struct device *) to
> gce_register_device(). gce_register_device() could then access the
> device's of_node to extract its physical address range, and look up
> its physical address in its table of per-soc of
> "device_address:gce_subsys_address" entries. If the physical address
> is in a valid subsys ranges, the gce_register_device would cache the
> subsys address, and an offset in a (struct gce_consumer).
> gce_register_device() could then add this struct to a struct list_head
> of gce_consumers, and finally return a pointer to it back to the
> caller.
>
> Later, the gce consumer could pass in ths (struct gce_consumer *) when
> make gce calls, along with the *offset* (not the physical address or
> virtual address) for the register that it wishes to access. Then the
> gce driver can simply use the gce_consumer->subsys entry to create a
> gce address from the passed in offset.
>
> This will keep the binding very simple, and would remove the need to
> convert from device virtual to physical addresses by the gce consumer,
> but require a little more per-gce-consumer setup.
>
> -Dan

Hi Dan,

When I try to implement this comment, I realize the only benefit from
this comment is to wrap physical address.

Recall from my previous reply: gce address = subsys + valid low bits.
So, CMDQ driver still need to do "(Base + offset) & valid mask" to get
gce valid low bits.
Current implementation let display driver do "base + offset".
This comment just transfers this calculation from display driver to CMDQ
driver.

However, this comment will let CMDQ interface (behavior) become more
complicated, e.g. gce_register_device(), struct gce_consumer, and int
cmdq_rec_write(struct cmdq_rec *handle, u32 value, struct gce_consumer
*consumer, u32 offset)

Do you think it is worth to do this effort to wrap physical address?

Thanks,
HS Liao