Re: [PATCH 2/3] mfd: lpc_ich: use a correct mask for the GPIO base address

[Lee Jones]

On Sat, 23 Jan 2016, Antoine Tenart wrote:

> The GPIO base address is read from the GPIOBASE register. The first
> bit must be cleared as it can be hardwired to 1 to represent the i/o
> space. Other bits are either containing the base address of are
> reserved. They should not be cleared as all the chipsets do not have
> the same reserved bits.
> 
> Signed-off-by: Antoine Tenart <antoine.tenart@xxxxxxxxxxxxxxxxxx>
> ---
>  drivers/mfd/lpc_ich.c | 5 ++++-
>  1 file changed, 4 insertions(+), 1 deletion(-)

Applied, thanks.

> diff --git a/drivers/mfd/lpc_ich.c b/drivers/mfd/lpc_ich.c
> index b514f3cf140d..f13a5ded3958 100644
> --- a/drivers/mfd/lpc_ich.c
> +++ b/drivers/mfd/lpc_ich.c
> @@ -921,7 +921,10 @@ static int lpc_ich_init_gpio(struct pci_dev *dev)
>  gpe0_done:
>  	/* Setup GPIO base register */
>  	pci_read_config_dword(dev, priv->gbase, &base_addr_cfg);
> -	base_addr = base_addr_cfg & 0x0000ff80;
> +
> +	/* Clear the i/o flag */
> +	base_addr = base_addr_cfg & ~BIT(0);
> +
>  	if (!base_addr) {
>  		dev_notice(&dev->dev, "I/O space for GPIO uninitialized\n");
>  		ret = -ENODEV;

-- 
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org â Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog