[PATCH 8/9] extcon: arizona: Use the micd_clamp for interrupts if it is available

[Charles Keepax]

Currently we only use the microphone clamp IRQ if GPIO5 is being used as
a second jack detection pin. But we should be using it on any system
where the clamp is available. This patch updates the driver to do so.

Signed-off-by: Charles Keepax <ckeepax@xxxxxxxxxxxxxxxxxxxxxxxxxxx>
---
 drivers/extcon/extcon-arizona.c |    6 +++---
 1 files changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/extcon/extcon-arizona.c b/drivers/extcon/extcon-arizona.c
index ece5892..9255c1f 100644
--- a/drivers/extcon/extcon-arizona.c
+++ b/drivers/extcon/extcon-arizona.c
@@ -1057,7 +1057,7 @@ static irqreturn_t arizona_jackdet(int irq, void *data)
 
 	mutex_lock(&info->lock);
 
-	if (arizona->pdata.jd_gpio5) {
+	if (info->micd_clamp) {
 		mask = ARIZONA_MICD_CLAMP_STS;
 		present = 0;
 	} else {
@@ -1504,7 +1504,7 @@ static int arizona_extcon_probe(struct platform_device *pdev)
 	pm_runtime_idle(&pdev->dev);
 	pm_runtime_get_sync(&pdev->dev);
 
-	if (arizona->pdata.jd_gpio5) {
+	if (info->micd_clamp) {
 		jack_irq_rise = ARIZONA_IRQ_MICD_CLAMP_RISE;
 		jack_irq_fall = ARIZONA_IRQ_MICD_CLAMP_FALL;
 	} else {
@@ -1609,7 +1609,7 @@ static int arizona_extcon_remove(struct platform_device *pdev)
 			   ARIZONA_MICD_CLAMP_CONTROL,
 			   ARIZONA_MICD_CLAMP_MODE_MASK, 0);
 
-	if (arizona->pdata.jd_gpio5) {
+	if (info->micd_clamp) {
 		jack_irq_rise = ARIZONA_IRQ_MICD_CLAMP_RISE;
 		jack_irq_fall = ARIZONA_IRQ_MICD_CLAMP_FALL;
 	} else {
-- 
1.7.2.5

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/