Re: [PATCH] Input: psmouse - add small delay for IBM trackpoint pass-through mode

[Andreas Mohr]

Hi,

[rogue out-of-band reply, sorry - lkml.org mail info is broken]

> There are trackpoint devices that fail to respond to the PS2 command
> PSMOUSE_CMD_GETID if immediately queried after the parent device is
> deactivated. Add a small delay for the hardware to get in a sane state
> before sending any PS2 commands.

Hmm, "deactivated"?
Probably a parent needs to be "activated" for a passthrough device
(child device?)
to be able to communicate? (I don't know much about these things though...)


> +		usleep_range(10000, 15000);

Ah, used _range() API - strong bonus points
for caring about wakeup minimization! :)

(and I take it you surely cared to check proper device operation
at both cases of doing usleep()
with either upper or lower delay amount specified... ;)




In general it's somewhat sad
to see an unconditional implementation
via woefully imprecise delay-only operation here -
is there a way to have it implemented
as a properly *handshaked* protocol,
i.e. try (re-)doing some other query type
which would fail until init is ok or timeout?
OTOH in that case PSMOUSE_CMD_GETID probably happens to be
just that kind of "handshaked success" query type to be used here...


Or, IOW (pseudo code):

delay;
if (!query()) fail;

sounds rather worse from a handshaked-protocol POV than

while (retries_remaining)
    if (query()) break;
    delay;


This reasoning would probably suggest
that such a loop should be added *within* psmouse_probe(), at the first
check (i.e., PSMOUSE_CMD_GETID).

OTOH that handshaked loop is only feasible
if doing repeated PSMOUSE_CMD_GETID query attempts
is actually supported (tolerated) by devices
(vs. no-op delaying and *then* trying one time only),
i.e. that repeated PSMOUSE_CMD_GETID queries will succeed
rather than fail or even block...



BTW, to make it obvious why non-handshaked operation may easily end up worse:
certain devices (out of a couple thousands of different
China-made human interface device models
which will be relevant here ;)
might perhaps *require* getting queried immediately *without* any prior delay,
in which case the first (AND LAST!) PSMOUSE_CMD_GETID query
after the (your) delay
would now already fail for those devices...



HTH,

Andreas Mohr

-- 
GNU/Linux. It's not the software that's free, it's you.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/