Re: [linux-sunxi] [RFC] ARM: dts: sunxi: Add regulators and board-specific operating points for LeMaker BananaPi

[Timo Sigurdsson]

Hi,

Chen-Yu Tsai schrieb am 27.07.2015 15:14:
>> ChenYu (in the CC), since you did most of the original work here, do
>> you know why we have an op at 0.9 volt, but none of our boards allow the
>> voltage to go that low in the regulator settings ?
> 
> I'm on vacation now, so apologies for the bad formatting.
> 
> The OPPs are from a common subset
> of the settings from the fex files available
> at the time. Some fex files actually set
> min and max voltage thus eliminating
> the highest and lowest OPPs.
> 
> At least that is how Maxime and I
> interpreted them.

IMHO for a common maximum opp that's a good approach. But for the lowest
frequency setting, it would seem more logical to me, to raise the voltage
to a point where all boards will run fine with them, unless those boards 
cannot handle the frequency regardless of the higher voltage.

Regards,

Timo
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/