Re: [PATCH v8 3/5] mtd: nand: vf610_nfc: add device tree bindings

From: Shawn Guo
Date: Mon Jul 27 2015 - 21:05:38 EST


On Mon, Jul 27, 2015 at 06:42:43PM +0200, Stefan Agner wrote:
> Signed-off-by: Bill Pringlemeir <bpringlemeir@xxxxxxxxx>
> Signed-off-by: Stefan Agner <stefan@xxxxxxxx>

Acked-by: Shawn Guo <shawnguo@xxxxxxxxxx>

> ---
> .../devicetree/bindings/mtd/vf610-nfc.txt | 45 ++++++++++++++++++++++
> 1 file changed, 45 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/mtd/vf610-nfc.txt
>
> diff --git a/Documentation/devicetree/bindings/mtd/vf610-nfc.txt b/Documentation/devicetree/bindings/mtd/vf610-nfc.txt
> new file mode 100644
> index 0000000..cae5f25
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/mtd/vf610-nfc.txt
> @@ -0,0 +1,45 @@
> +Freescale's NAND flash controller (NFC)
> +
> +This variant of the Freescale NAND flash controller (NFC) can be found on
> +Vybrid (vf610), MPC5125, MCF54418 and Kinetis K70.
> +
> +Required properties:
> +- compatible: Should be set to "fsl,vf610-nfc"
> +- reg: address range of the NFC
> +- interrupts: interrupt of the NFC
> +- nand-bus-width: see nand.txt
> +- nand-ecc-mode: see nand.txt
> +- nand-on-flash-bbt: see nand.txt
> +- assigned-clocks: main clock from the SoC, for Vybrid <&clks VF610_CLK_NFC>;
> +- assigned-clock-rates: The NAND bus timing is derived from this clock
> + rate and should not exceed maximum timing for any NAND memory chip
> + in a board stuffing. Typical NAND memory timings derived from this
> + clock are found in the SoC hardware reference manual. Furthermore,
> + there might be restrictions on maximum rates when using hardware ECC.
> +
> +- #address-cells, #size-cells : Must be present if the device has sub-nodes
> + representing partitions.
> +
> +Required properties for hardware ECC:
> +- nand-ecc-strength: supported strengths are 24 and 32 bit (see nand.txt)
> +- nand-ecc-step-size: step size equals page size, currently only 2k pages are
> + supported
> +
> +Example:
> +
> + nfc: nand@400e0000 {
> + compatible = "fsl,vf610-nfc";
> + #address-cells = <1>;
> + #size-cells = <1>;
> + reg = <0x400e0000 0x4000>;
> + interrupts = <GIC_SPI 83 IRQ_TYPE_LEVEL_HIGH>;
> + clocks = <&clks VF610_CLK_NFC>;
> + clock-names = "nfc";
> + assigned-clocks = <&clks VF610_CLK_NFC>;
> + assigned-clock-rates = <33000000>;
> + nand-bus-width = <8>;
> + nand-ecc-mode = "hw";
> + nand-ecc-strength = <32>;
> + nand-ecc-step-size = <2048>;
> + nand-on-flash-bbt;
> + };
> --
> 2.4.5
>
>
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
>
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/