Re: [PATCH] clk: qcom: Use parent rate when set rate to pixel RCG clock

[Archit Taneja]

On 06/26/2015 04:05 AM, Hai Li wrote:
> Since the parent rate has been recalculated, pixel RCG clock
> should rely on it to find the correct M/N values during set_rate,
> instead of calling __clk_round_rate() to its parent again.

Tested-by: Archit Taneja <architt@xxxxxxxxxxxxxx>

> Signed-off-by: Hai Li <hali@xxxxxxxxxxxxxx>
> ---
>   drivers/clk/qcom/clk-rcg2.c | 3 ++-
>   1 file changed, 2 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/clk/qcom/clk-rcg2.c b/drivers/clk/qcom/clk-rcg2.c
> index 4d3e2f7..b344899 100644
> --- a/drivers/clk/qcom/clk-rcg2.c
> +++ b/drivers/clk/qcom/clk-rcg2.c
> @@ -615,10 +615,11 @@ static int clk_pixel_set_rate(struct clk_hw *hw, unsigned long rate,
>   	if (!parent)
>   		return -EINVAL;
>
> +	src_rate = parent_rate;
> +
>   	for (; frac->num; frac++) {
>   		request = (rate * frac->den) / frac->num;
>
> -		src_rate = __clk_round_rate(parent, request);
>   		if ((src_rate < (request - delta)) ||
>   			(src_rate > (request + delta)))
>   			continue;

--
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/