Re: [PATCH] clk: qcom: fix RCG M/N counter configuration

[Archit Taneja]

On 03/20/2015 10:58 AM, Stephen Boyd wrote:
> On 03/04, Archit Taneja wrote:
> > Currently, a RCG's M/N counter (used for fraction division) is set to either
> > 'bypass' (counter disabled) or 'dual edge' (counter enabled) based on whether
> > the corresponding rcg struct has a mnd field specified and a non-zero N.
> >
> > In the case where M and N are the same value, the M/N counter is still enabled
> > by code even though no division takes place. Leaving the RCG in such a state
> > can result in improper behavior. This was observed with the DSI pixel clock RCG
> > when M and N were both set to 1.
> >
> > Add an additional check (M != N) to enable the M/N counter only when it's needed
> > for fraction division.
> >
> > Signed-off-by: Archit Taneja <architt@xxxxxxxxxxxxxx>
> > ---
>
> I'm going to queue this up for 4.1 given that this isn't a new
> regression. But I'll tag it for stable so that we get it into all
> the stable trees.

Great, that sounds good.

Thanks,
Archit


--
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/