Re: [PATCH 00/18] sync opal.h with firmware

From: Stewart Smith
Date: Tue Feb 10 2015 - 00:10:51 EST


Michael Ellerman <mpe@xxxxxxxxxxxxxx> writes:
> I'm going to be a total pain, and suggest that this is the wrong approach :)
>
> I was on board until patch 15, where you have to add an #ifdef SKIBOOT to guard
> an include, and you have to remove an include on the Linux side.

(the Linux include was actually not used it seems)

> I think the better solution would be to pull all the common parts out into a
> new file, opal-api.h. That file would define the API between Linux & Skiboot,
> and absolutely nothing else.

Sounds fine.

> Both Linux and Skiboot would continue to have an opal.h, which would include
> opal-api.h, and then anything else needed on either side to make a functioning
> opal.h - eg. other includes & definitions (SG_ENTRIES_PER_NODE).
>
> It would also have the advantage that because opal-api.h is a new file, we can
> get it synced from the beginning and not worry about all the whitespace &
> rearranging patches. ie. there'd just be one patch on both sides to add the new
> file and move definitions into it from opal.h.

Sure. I was doing it bit by bit just so that it was reviewable that I
didn't miss anything or violently screw anything up. Plus, there were
things that should be changed in skiboot as well.

> If you don't violently disagree I'll do a patch for that and we can see how it
> looks?

Not violently :)

I'd go back and do a similar thing to skiboot to make them match again
though, having linux/opal-api.h match skiboot/opal.h would just cause
swearing fits :)

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/