Re: [PATCH] iio: adc: exynos_adc: Add support for ADCv3 on exynos7

From: Abhilash Kesavan
Date: Sat Nov 01 2014 - 00:00:35 EST


Hi Chanwoo,

On Fri, Oct 31, 2014 at 9:44 PM, Chanwoo Choi <cwchoi00@xxxxxxxxx> wrote:
> Hi Abhilash,
>
> On Fri, Oct 31, 2014 at 11:01 PM, Abhilash Kesavan
> <kesavan.abhilash@xxxxxxxxx> wrote:
>> Hi Chanwoo,
>>
>> Thanks for the quick response.
>>
>> On Fri, Oct 31, 2014 at 6:17 PM, Chanwoo Choi <cw00.choi@xxxxxxxxxxx> wrote:
>>> Hi Abhilash,
>>>
>>> On 10/31/2014 09:38 PM, Abhilash Kesavan wrote:
>>>> The ADC on exynos7 is quite similar to ADCv2. The differences are as
>>>> follows:
>>>> - v3 has 8 input channels (10 in v2).
>>>> - v3 does not include an ADC PHY control register.
>>>> - Some ADC_CON2 register bits being used in v2 are listed as
>>>> reserved in v3. This results in a different init_hw function
>>>> for v3.
>>>>
>>>> Signed-off-by: Abhilash Kesavan <a.kesavan@xxxxxxxxxxx>
>>>> ---
>>>> - Based on Naveen's "iio: exynos-adc: use syscon instead of ioremap" patchset
>>>> http://comments.gmane.org/gmane.linux.kernel.iio/13943
>>>>
>>>> .../devicetree/bindings/arm/samsung/exynos-adc.txt | 2 ++
>>>> drivers/iio/adc/exynos_adc.c | 32 ++++++++++++++++++++
>>>> 2 files changed, 34 insertions(+)
>>>>
>>>> diff --git a/Documentation/devicetree/bindings/arm/samsung/exynos-adc.txt b/Documentation/devicetree/bindings/arm/samsung/exynos-adc.txt
>>>> index c368210..a11e32c 100644
>>>> --- a/Documentation/devicetree/bindings/arm/samsung/exynos-adc.txt
>>>> +++ b/Documentation/devicetree/bindings/arm/samsung/exynos-adc.txt
>>>> @@ -14,6 +14,8 @@ Required properties:
>>>> for exynos4412/5250 and s5pv210 controllers.
>>>> Must be "samsung,exynos-adc-v2" for
>>>> future controllers.
>>>> + Must be "samsung,exynos-adc-v3" for
>>>> + the ADC in Exynos7 and compatibles
>>>
>>> I prefer to use 'exynos7-adc' instead of 'exynos-adc-v3'.
>>> Exynos7 has little different from existing ADCv2.
>>
>> Sure, I'll change it. The reason for my choosing v3 was that reading
>> the version register (0x20 offset) showed a value of 0x80000009 in
>> Exynos7 as against 0x80000008 in both 5420 and 3250.
>>>
>>> Also, If you want to use 'exynos-adc-v3' compatible,
>>> Exynos7's TRM have to include the correct version(v3) infromation.
>>
>> I could not see any mention of the ADC controller version in the
>> Exynos7 UM other than the version register. Does that mean it is v2 ?
>
> So am I. I don't see any version number of ADC in Exynos TRM.
OK, considering the small differences between ADCv2 and this
controller, I will change the compatible to exynos7-adc.
Patch will be posted in a bit.
>
> Additionally,
> I have a question about Exynos7. If you possible,
> did you tell me about full name of Exynos7 SoC (e.g., Exynos5433, Exynos52..)?
The soc name is Exynos7 and it has 4 A57 cores.
>
> Best Regards,
> Chanwoo Choi
>
>>
>> Regards,
>> Abhilash
>>>
>>> Thanks,
>>> Chanwoo Choi
>>>
>>>
>>>
>>>> Must be "samsung,exynos3250-adc" for
>>>> controllers compatible with ADC of Exynos3250.
>>>> Must be "samsung,s3c2410-adc" for
>>>> diff --git a/drivers/iio/adc/exynos_adc.c b/drivers/iio/adc/exynos_adc.c
>>>> index fe03177..74d0a9d 100644
>>>> --- a/drivers/iio/adc/exynos_adc.c
>>>> +++ b/drivers/iio/adc/exynos_adc.c
>>>> @@ -390,6 +390,35 @@ static const struct exynos_adc_data exynos3250_adc_data = {
>>>> .start_conv = exynos_adc_v2_start_conv,
>>>> };
>>>>
>>>> +static void exynos_adc_v3_init_hw(struct exynos_adc *info)
>>>> +{
>>>> + u32 con1, con2;
>>>> +
>>>> + if (info->data->needs_adc_phy)
>>>> + regmap_write(info->pmu_map, info->data->phy_offset, 1);
>>>> +
>>>> + con1 = ADC_V2_CON1_SOFT_RESET;
>>>> + writel(con1, ADC_V2_CON1(info->regs));
>>>> +
>>>> + con2 = readl(ADC_V2_CON2(info->regs));
>>>> + con2 &= ~ADC_V2_CON2_C_TIME(7);
>>>> + con2 |= ADC_V2_CON2_C_TIME(0);
>>>> + writel(con2, ADC_V2_CON2(info->regs));
>>>> +
>>>> + /* Enable interrupts */
>>>> + writel(1, ADC_V2_INT_EN(info->regs));
>>>> +}
>>>> +
>>>> +static const struct exynos_adc_data exynos_adc_v3_data = {
>>>> + .num_channels = MAX_ADC_V1_CHANNELS,
>>>> + .mask = ADC_DATX_MASK, /* 12 bit ADC resolution */
>>>> +
>>>> + .init_hw = exynos_adc_v3_init_hw,
>>>> + .exit_hw = exynos_adc_v2_exit_hw,
>>>> + .clear_irq = exynos_adc_v2_clear_irq,
>>>> + .start_conv = exynos_adc_v2_start_conv,
>>>> +};
>>>> +
>>>> static const struct of_device_id exynos_adc_match[] = {
>>>> {
>>>> .compatible = "samsung,s3c2410-adc",
>>>> @@ -413,6 +442,9 @@ static const struct of_device_id exynos_adc_match[] = {
>>>> .compatible = "samsung,exynos-adc-v2",
>>>> .data = &exynos_adc_v2_data,
>>>> }, {
>>>> + .compatible = "samsung,exynos-adc-v3",
>>>> + .data = &exynos_adc_v3_data,
>>>> + }, {
>>>> .compatible = "samsung,exynos3250-adc",
>>>> .data = &exynos3250_adc_data,
>>>> },
>>>>
>>>
>> --
>> To unsubscribe from this list: send the line "unsubscribe linux-iio" in
>> the body of a message to majordomo@xxxxxxxxxxxxxxx
>> More majordomo info at http://vger.kernel.org/majordomo-info.html
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/