[PATCH v4 0/14] input: cyapa: re-architecture driver to support multi-trackpads in one driver
From: Dudley Du
Date: Thu Jul 17 2014 - 02:45:32 EST
This patch set is made based on kernel 3.16.0-rc5.
It's aimed to re-architecture the cyapa driver to support
old gen3 trackpad device and new gen5 trackpad device in one
cyapa driver for easily productions support based on
customers' requirements, and add sysfs functions and interfaces
supported that required by users and customers.
Because the earlier gen3 and the latest gen5 trackpad devies using
two different chipsets, and have different protocol and interfaces.
If supported these two trackpad devices in two different drivers, then
it will be difficult to manage productions and later firmware updates.
it will cause customer don't know which one to use and update
because these two trackpad devices have been used and integrated
in same one productions at a time, so must to support these two trackpad
devices in same on driver.
Compare to v3, it has below changes:
1) Eliminate irq-state-remembering logic, remove irq help functions;
2) Remove state sync help functions instead of mutex_lock/mutex_unlock;
3) Fix comments and charaters errors and not consistent issues.
4) Fix other issues that pointed out in the review.
The new architecture is made of:
cyapa.c - the core of the architecture, supply interfaces and
functions to system and read trackpad devices.
cyapa_gen3.c - functions support for gen3 trackpad devices,
cyapa_gen5.c - functions support for gen5 trackpad devices.
Beside this introduction patch, it has 14 patches listed as below.
For these patches each one is patched based on previous one.
patch 1/14: re-architecture cyapa driver with core functions,
and applying the device detecting function in async thread to speed
up system boot time.
patch 2/14: add cyapa driver power management interfaces support.
patch 3/14: add cyapa driver runtime power management interfaces support.
patch 4/14: add cyapa key function interfaces in sysfs system.
Including read firmware version, get production ID, read baseline,
re-calibrate trackpad baselines and do trackpad firmware update.
patch 5/14: add read firmware image and read raw trackpad device'
sensors' raw data interface in debugfs system.
patch 6/14: add gen3 trackpad device basic functions support.
patch 7/14: add gen3 trackpad device firmware update function support.
patch 8/14: add gen3 trackpad device report baseline and do force
re-calibrate functions support.
patch 9/14: add gen3 trackpad device read firmware image function support.
patch 10/14: add gen5 trackpad device basic functions support.
patch 11/14: add gen5 trackpad device firmware update function support.
patch 12/14: add gen5 trackpad device report baseline and do force
re-calibrate functions support.
patch 13/14: add gen5 trackpad device read firmware image and report
sensors' raw data values functions support.
patch 14/14: add function to monitor LID close event to off trackpad device.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/