Re: timers & suspend

From: Daniel Lezcano
Date: Thu Jul 03 2014 - 13:26:10 EST


On 07/03/2014 06:09 PM, SÃren Brinkmann wrote:
On Thu, 2014-07-03 at 02:21PM +0200, Daniel Lezcano wrote:
On 06/30/2014 08:39 PM, SÃren Brinkmann wrote:
Hi,

I'm currently working on suspend for Zynq and try to track down some
spurious wakes. It looks like the spurious wakes are caused by timers,
hence I was wondering whether there are any special requirements for
timer drivers when it comes to suspend support or if I just missed
something.

Zynq sets the 'IRQCHIP_MASK_ON_SUSPEND' flag, which should mask all
interrupts but the wake source. Reading through kernel/irq/pm.c
indicates, that timer interrupts get some special treatment though.
Therefore I implemented some suspend/resume callbacks for the
cadence_ttc which disable and clear the timer's interrupts when going
into suspend. That seems to mitigate the issue quite a bit, but I still
saw spurious wakes - just a lot less often.
Digging a little deeper revealed, the spurious wakes are caused by the
ARM's smp_twd timer now. Given that that driver is probably used by a few
more ARM platforms, I get the feeling that I'm missing something.

Do you receive any interrupt from the cadence_ttc ? (/proc/interrupts)

That's funny because I realize that you cadence ttc timer is never
used as there are the architected timers. The cadence ttc would be
only useful if there were an idle state powering down the smp_twd
timers but it is not the case on this board, IIUC.
Yes they are used. They TTC is the only broadcast capable timer for
Zynq. In my experience, I can not even boot without it (may have
dependencies on CPUidle or something).

Actually the cpuidle driver is wrong. It assumes the state #1 will power off the different cores with their architected timers and then switch to the broadcast timer. But this one is not needed as we don't power down the core with the twd timers, so no need to switch to a backup timer device.

The implementation of the DDR self refresh idle state (incoming patchset) removes the cpu_pm notifiers + the flag TIMER_STOP. The result is 0 interrupts for ttc cadence timer. I removed in the dts the cadence ttc and my board booted without problem (it is a zynq 702).

Except I missed something, the cadence ttc is actually not used at all.

It's probably worth mentioning that the suspend state in Zynq does not
power off the CPU cores. It just asserts the resets on secondary cores
and the primary one waits in wfi.

Why do you need to reset them ?
CPU0 is not reset, but all secondary cores are. That is as close to
power off as we get and works well with hotplug.

Ok, I was not aware of this approach. Is there any patchset available in the net ?

Thanks

-- Daniel

--
<http://www.linaro.org/> Linaro.org â Open source software for ARM SoCs

Follow Linaro: <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/