[PATCH v2 1/1] PINCTRL: Warn if direct IRQ GPIO set to output
From: eric . ernst
Date: Mon Jun 02 2014 - 17:14:00 EST
From: Eric Ernst <eric.ernst@xxxxxxxxxxxxxxx>
For Baytrail, you should never set a GPIO set to direct_irq
to output mode. When direct_irq_en is set for a GPIO, it is
tied directly to an APIC internally, and making the pad output
does not make any sense. Assert a WARN() in the event this happens.
Signed-off-by: Eric Ernst <eric.ernst@xxxxxxxxxxxxxxx>
---
drivers/pinctrl/pinctrl-baytrail.c | 19 +++++++++++++++----
1 file changed, 15 insertions(+), 4 deletions(-)
diff --git a/drivers/pinctrl/pinctrl-baytrail.c b/drivers/pinctrl/pinctrl-baytrail.c
index e59983423991..fde3767df254 100644
--- a/drivers/pinctrl/pinctrl-baytrail.c
+++ b/drivers/pinctrl/pinctrl-baytrail.c
@@ -47,6 +47,7 @@
#define BYT_TRIG_POS BIT(25)
#define BYT_TRIG_LVL BIT(24)
#define BYT_PIN_MUX 0x07
+#define BYT_DIRECTIRQ BIT(27)
/* BYT_VAL_REG register bits */
#define BYT_INPUT_EN BIT(2) /* 0: input enabled (active low)*/
@@ -256,19 +257,29 @@ static int byt_gpio_direction_output(struct gpio_chip *chip,
unsigned gpio, int value)
{
struct byt_gpio *vg = to_byt_gpio(chip);
- void __iomem *reg = byt_gpio_reg(chip, gpio, BYT_VAL_REG);
+ void __iomem *conf_reg = byt_gpio_reg(chip, gpio, BYT_CONF0_REG);
+ void __iomem *value_reg = byt_gpio_reg(chip, gpio, BYT_VAL_REG);
unsigned long flags;
u32 reg_val;
spin_lock_irqsave(&vg->lock, flags);
- reg_val = readl(reg) | BYT_DIR_MASK;
+ /*
+ * Before making any direction modifications, do a check if gpio
+ * is set for direct IRQ. On baytrail, setting GPIO to output does
+ * not make sense, so let's at least warn the caller before they shoot
+ * themselves in the foot.
+ */
+ WARN((readl(conf_reg) & BYT_DIRECTIRQ),
+ "Potential Error: Setting GPIO with direct_irq_en to output");
+
+ reg_val = readl(value_reg) | BYT_DIR_MASK;
reg_val &= ~BYT_OUTPUT_EN;
if (value)
- writel(reg_val | BYT_LEVEL, reg);
+ writel(reg_val | BYT_LEVEL, value_reg);
else
- writel(reg_val & ~BYT_LEVEL, reg);
+ writel(reg_val & ~BYT_LEVEL, value_reg);
spin_unlock_irqrestore(&vg->lock, flags);
--
1.7.9.5
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/