Re: mxs-auart gives data from previous run after close and reopen

From: Peter Hurley
Date: Fri Mar 21 2014 - 06:17:26 EST


On 03/21/2014 04:21 AM, Stanislav Meduna wrote:
On 21.03.2014 02:39, Peter Hurley wrote:

Does disabling the fifo on shutdown clear the fifo?

I did not try this, but if my theory is correct, it would
not help, as all this does is reducing the FIFO length
to one character. So you'd still get up to two characters:
one in the "FIFO" - it could get there a microsecond after
you disable the FIFO before you gate the clock - and one
being received into the shift register (garbled by shutting
down the clock in the middle of the reception that was
resumed when clock was resumed on startup). Note that one
can get preempted here, so the instructions next to each
other can be milliseconds apart in reality.

IMHO we need a soft-reset here.

The reason why I asked about disabling the fifo is
because on other uarts, changing from non-fifo to fifo
mode clears the fifo. The idea being that, on shutdown,
if the uart is changed to non-fifo mode then, on startup,
the uart will be changed back to fifo mode, clearing the
fifo.

Unfortunately, the i.mx28 reference doesn't say what
happens to the data when the fifo is reconfigured this
way, and why I suggested the experiment.

Regards,
Peter Hurley

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/