Re: [RFC PATCH] vfio/iommu_type1: Multi-IOMMU domain support

From: Alex Williamson
Date: Mon Jan 20 2014 - 13:39:25 EST


On Mon, 2014-01-20 at 18:30 +0000, Varun Sethi wrote:
>
> > -----Original Message-----
> > From: Alex Williamson [mailto:alex.williamson@xxxxxxxxxx]
> > Sent: Monday, January 20, 2014 9:51 PM
> > To: Sethi Varun-B16395
> > Cc: iommu@xxxxxxxxxxxxxxxxxxxxxxxxxx; linux-kernel@xxxxxxxxxxxxxxx
> > Subject: Re: [RFC PATCH] vfio/iommu_type1: Multi-IOMMU domain support
> >
> > On Mon, 2014-01-20 at 14:45 +0000, Varun Sethi wrote:
> > >
> > > > -----Original Message-----
> > > > From: Alex Williamson [mailto:alex.williamson@xxxxxxxxxx]
> > > > Sent: Saturday, January 18, 2014 2:06 AM
> > > > To: Sethi Varun-B16395
> > > > Cc: iommu@xxxxxxxxxxxxxxxxxxxxxxxxxx; linux-kernel@xxxxxxxxxxxxxxx
> > > > Subject: [RFC PATCH] vfio/iommu_type1: Multi-IOMMU domain support
> > > >
> > > > RFC: This is not complete but I want to share with Varun the
> > > > dirrection I'm thinking about. In particular, I'm really not sure
> > > > if we want to introduce a "v2" interface version with slightly
> > > > different unmap semantics. QEMU doesn't care about the difference,
> > > > but other users might. Be warned, I'm not even sure if this code
> > works at the moment.
> > > > Thanks,
> > > >
> > > > Alex
> > > >
> > > >
> > > > We currently have a problem that we cannot support advanced features
> > > > of an IOMMU domain (ex. IOMMU_CACHE), because we have no guarantee
> > > > that those features will be supported by all of the hardware units
> > > > involved with the domain over its lifetime. For instance, the Intel
> > > > VT-d architecture does not require that all DRHDs support snoop
> > > > control. If we create a domain based on a device behind a DRHD that
> > > > does support snoop control and enable SNP support via the
> > > > IOMMU_CACHE mapping option, we cannot then add a device behind a
> > > > DRHD which does not support snoop control or we'll get reserved bit
> > > > faults from the SNP bit in the pagetables. To add to the
> > > > complexity, we can't know the properties of a domain until a device
> > is attached.
> > > [Sethi Varun-B16395] Effectively, it's the same iommu and iommu_ops
> > > are common across all bus types. The hardware feature differences are
> > > abstracted by the driver.
> >
> > That's a simplifying assumption that is not made anywhere else in the
> > code. The IOMMU API allows entirely independent IOMMU drivers to
> > register per bus_type. There is no guarantee that all devices are backed
> > by the same IOMMU hardware unit or make use of the same iommu_ops.
> >
> [Sethi Varun-B16395] ok
>
> > > > We could pass this problem off to userspace and require that a
> > > > separate vfio container be used, but we don't know how to handle
> > > > page accounting in that case. How do we know that a page pinned in
> > > > one container is the same page as a different container and avoid
> > > > double billing the user for the page.
> > > >
> > > > The solution is therefore to support multiple IOMMU domains per
> > > > container. In the majority of cases, only one domain will be
> > > > required since hardware is typically consistent within a system.
> > > > However, this provides us the ability to validate compatibility of
> > > > domains and support mixed environments where page table flags can be
> > > > different between domains.
> > > >
> > > > To do this, our DMA tracking needs to change. We currently try to
> > > > coalesce user mappings into as few tracking entries as possible.
> > > > The problem then becomes that we lose granularity of user mappings.
> > > > We've never guaranteed that a user is able to unmap at a finer
> > > > granularity than the original mapping, but we must honor the
> > > > granularity of the original mapping. This coalescing code is
> > > > therefore removed, allowing only unmaps covering complete maps. The
> > > > change in accounting is fairly small here, a typical QEMU VM will
> > > > start out with roughly a dozen entries, so it's arguable if this
> > coalescing was ever needed.
> > > >
> > > > We also move IOMMU domain creation to the point where a group is
> > > > attached to the container. An interesting side-effect of this is
> > > > that we now have access to the device at the time of domain creation
> > > > and can probe the devices within the group to determine the bus_type.
> > > > This finally makes vfio_iommu_type1 completely device/bus agnostic.
> > > > In fact, each IOMMU domain can host devices on different buses
> > > > managed by different physical IOMMUs, and present a single DMA
> > > > mapping interface to the user. When a new domain is created,
> > > > mappings are replayed to bring the IOMMU pagetables up to the state
> > > > of the current container. And of course, DMA mapping and unmapping
> > > > automatically traverse all of the configured IOMMU domains.
> > > >
> > > [Sethi Varun-B16395] This code still checks to see that devices being
> > > attached to the domain are connected to the same bus type. If we
> > > intend to merge devices from different bus types but attached to
> > > compatible domains in to a single domain, why can't we avoid the bus
> > > check? Why can't we remove the bus dependency from domain allocation?
> >
> > So if I were to test iommu_ops instead of bus_type (ie. assume that if a
> > if an IOMMU driver manages iommu_ops across bus_types that it can accept
> > the devices), would that satisfy your concern?
> [Sethi Varun-B16395] I think so. Checking for iommu_ops should allow iommu groups from different bus_types, to share a domain.
>
> >
> > It may be possible to remove the bus_type dependency from domain
> > allocation, but the IOMMU API currently makes the assumption that there's
> > one IOMMU driver per bus_type.
> [Sethi Varun-B16395] Is that a valid assumption?

Perhaps it's really more of a requirement than an assumption.
Theoretically there is no reason we couldn't see a system with multiple
IOMMUs requiring different IOMMU drivers on the same bus_type. In
practice, we don't. We may need to change this in the future, but it's
sufficient for now.

> > Your fix to remove the bus_type
> > dependency from iommu_domain_alloc() adds an assumption that there is
> > only one IOMMU driver for all bus_types. That may work on your platform,
> > but I don't think it's a valid assumption in the general case.
> [Sethi Varun-B16395] ok
>
> > If you'd like to propose alternative ways to remove the bus_type
> > dependency, please do. Thanks,
> >
> [Sethi Varun-B16395] My main concern, was to allow devices from different bus types, to share the iommu domain. I am fine if this can be handled from within vfio.

Ok, I think it can. Thanks,

Alex

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/