Re: [RFC PATCH 1/4] DRIVERS: IRQCHIP: Add crossbar irqchip driver

From: Santosh Shilimkar
Date: Thu Sep 12 2013 - 21:42:49 EST


On Thursday 12 September 2013 08:26 PM, Thomas Gleixner wrote:
> On Thu, 12 Sep 2013, Santosh Shilimkar wrote:
>> On Thursday 12 September 2013 06:22 PM, Thomas Gleixner wrote:
>>> Now the real question is, how that expansion mechanism is supposed to
>>> work. There are two possible scenarios:
>>>
>>> 1) Expand the number of handled interrupts beyond the GIC capacity:
>>>
>>> That requires a mechanism in CROSSBAR to map several CROSSBAR
>>> interrupts to a particular GIC interrupt and provide a demux
>>> mechanism to invoke the shared handlers.
>>>
>> This is not possible in hardware and not supported. Hardware has
>> no notion of muxing multiple IRQ's to generate 1 IRQ or ack etc
>> functionality. Its a simple MUX to tie knots between input and output
>> wires.
>
> It's not a MUX. It's a ROUTING mechanism. That's similar to the
> mechanisms which are used by MSI[X]. We assign arbitrary interrupt
> numbers to a device and route them to some underlying limited hardware
> interrupt controller.
>
>>> 2) Provide a mapping mechanism between possibly 250 interrupt numbers
>>> and a limitation of a total 160 active interrupts by the underlying
>>> GIC.
>>>
>> This is the need and problem we are trying to solve.
>
> Let me summarize:
>
> - GIC supports up to 160 interrupts
>
> - CROSSBAR supports up to 250 interrupts
>
> - CROSSBAR routes up to 160 out of 250 interrupts to the GIC ones
>
> - Drivers request a CROSSBAR interrupt number which must be mapped
> to some arbitrary available GIC irq number
>
Correct.

> So basically the CROSSBAR mechanism is pretty much the same as MSI[X]
> just in a different flavour and with a different set of semantics and
> limitations, i.e. poor mans MSI[X] with a new level of bogosity.
>
> So if CROSSBAR is going to be the new fangled SoC MSI[X] long term
> equivalent then you better provide some infrastructure for that and
> make the drivers ready to use it. Maybe check with the PCI/MSI folks
> to share some of the interfaces.
>
> If that whole thing is another onetime HW designers wet dream, then
> please go back to the limited but completely functional (Who is going
> to use more than 160 peripheral interrupts????) device tree model. I
> really have no interest to support hardware designer brain farts.
>
Thanks for clear NAK for irqchip approach. I should have looped you
in the discussion where I was also suggesting against the irqchip
approach. We will try to look at MSI stuff but if its get too
complicated am going to fall-back to the initial probe based
approach to achieve the functionality.

Thanks again for clear direction and useful discussion.

Regards,
Santosh
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/