Re: [PATCH 1/2] ARM: DTS: tegra: Add USB entries for Tegra30

[Tuomas Tynkkynen]

On 08/01/2013 01:13 AM, Stephen Warren wrote:
> On 07/31/2013 11:42 AM, Tuomas Tynkkynen wrote:
>> Add device tree entries for the 3 USB controllers and PHYs and
>> enable the third controller on Cardhu and Beaver boards.
>>
>> Fix VBUS regulator entries on Beaver. The GPIO pins were wrong.
> 
> That much is correct.
> 
>> Also, a third GPIO is required to power the pullup resistors that drive
>> the VBUS voltage switches, so add an regulator entry for that.
> 
> That is not true. GMI_AD13 / PH5 / 61 is a signal that pulls up all of
> USB1 VBUS, USB3 VBUS, and GMI_AD15, which as far as I can tell is
> entirely unrelated to USB in any way.

I sent a v2 that enables the internal pullups on those pins.

> This part of the change should be removed. I know you mentioned that
> downstream does this, but that means very little; there are many
> mistakes there.

It looks like the pullup resistor from PH5 to GMI_AD15 was added in a later board revision,
so the HW guys are to blame this time.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/