Re: [PATCH 01/15] drivers: phy: add generic PHY framework

[Tomasz Figa]

On Tuesday 23 of July 2013 17:14:20 Alan Stern wrote:
> On Tue, 23 Jul 2013, Tomasz Figa wrote:
> > > If you want to keep the phy struct completely separate from the
> > > board
> > > file, there's an easy way to do it.  Let's say the board file knows
> > > about N different PHYs in the system.  Then you define an array of N
> > > pointers to phys:
> > > 
> > > struct phy *(phy_address[N]);
> > > 
> > > In the platform data for both PHY j and its controller, store
> > > 
> > > &phy_address[j].  The PHY provider passes this cookie to phy_create:
> > > 	cookie = pdev->dev.platform_data;
> > > 	ret = phy_create(phy, cookie);
> > > 
> > > and phy_create simply stores: *cookie = phy.  The PHY consumer does
> > > 
> > > much the same the same thing:
> > > 	cookie = pdev->dev.platform_data;
> > > 	phy = phy_get(cookie);
> > > 
> > > phy_get returns *cookie if it isn't NULL, or an ERR_PTR otherwise.
> > 
> > OK, this can work. Again, just technically, because it's rather ugly.
> 
> There's no reason the phy_address things have to be arrays.  A separate
> individual pointer for each PHY would work just as well.
> 
> > Where would you want to have those phy_address arrays stored? There
> > are no board files when booting with DT. Not even saying that you
> > don't need to use any hacky schemes like this when you have DT that
> > nicely specifies relations between devices.
> 
> If everybody agrees DT has a nice scheme for specifying relations
> between devices, why not use that same scheme in the PHY core?

It is already used, for cases when consumer device has a DT node attached. 
In non-DT case this kind lookup translates loosely to something that is 
being done in regulator framework - you can't bind devices by pointers, 
because you don't have those pointers, so you need to use device names.

> > Anyway, board file should not be considered as a method to exchange
> > data between drivers. It should be used only to pass data from it to
> > drivers, not the other way. Ideally all data in a board file should
> > be marked as const and __init and dropped after system
> > initialization.
> 
> The phy_address things don't have to be defined or allocated in the
> board file; they could be set up along with the platform data.

There is no platform data when booting with DT.

> In any case, this was simply meant to be a suggestion to show that it
> is relatively easy to do what you need without using name or ID
> strings.

Sure. It's good to have different options discussed as well.

Best regards,
Tomasz

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/