Re: [PATCH v3 1/4] pinctrl-tz1090: add TZ1090 pinctrl driver

[James Hogan]

On 24/06/13 16:04, Linus Walleij wrote:
> On Thu, Jun 20, 2013 at 11:26 AM, James Hogan <james.hogan@xxxxxxxxxx> wrote:
> 
>> Add a pin control driver for the main pins on the TZ1090 SoC. This
>> doesn't include the low-power pins as they're controlled separately via
>> the Powerdown Controller (PDC) registers.
>>
>> Signed-off-by: James Hogan <james.hogan@xxxxxxxxxx>
>> Cc: Grant Likely <grant.likely@xxxxxxxxxx>
>> Cc: Rob Herring <rob.herring@xxxxxxxxxxx>
>> Cc: Rob Landley <rob@xxxxxxxxxxx>
>> Cc: Linus Walleij <linus.walleij@xxxxxxxxxx>
>> Cc: linux-doc@xxxxxxxxxxxxxxx
>> Cc: devicetree-discuss@xxxxxxxxxxxxxxxx
>> ---
>> Changes in v3:
>>  - separated from irq-imgpdc and removed arch/metag changes to allow
>>    these patches to go upstream separately via the pinctrl[/gpio] trees
>>    (particularly the pinctrl drivers depend on the new pinconf DT
>>    bindings).
>>  - some s/unsigned/unsigned int/.
>>  - some s/unsigned int/bool/ and use of BIT().
>>  - pinctrl-tz1090*: switch to generic pinconfig DT bindings and
>>    pinconf_generic_dump_config.
>>  - pinctrl-tz1090*: use tz1090, prefix for pins and function in DT
>>    bindings.
>>  - pinctrl-tz1090*: make internal functions static.
>>  - pinctrl-tz1090*: move initcall from postcore to arch.
> 
> Thanks James, patch applied.
> 
> Also thanks for helping out in getting the generic pinconf
> in place for some three different drivers for this merge window,
> this was very good for pinctrl at large.

Thanks Linus, and no problem!

Cheers
James

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/