Re: [PATCH v3 3/4] pinctrl-tz1090-pdc: add TZ1090 PDC pinctrl driver

[Linus Walleij]

On Thu, Jun 20, 2013 at 11:26 AM, James Hogan <james.hogan@xxxxxxxxxx> wrote:

> Add a pin control driver for the TZ1090's low power pins via the
> powerdown controller SOC_GPIO_CONTROL registers.
>
> These pins have individually controlled pull-up, and group controlled
> schmitt, slew-rate, drive-strength, and power-on-start (pos).
>
> The pdc_gpio0 and pdc_gpio1 pins can also be muxed onto the
> ir_mod_stable_out and ir_mod_power_out functions respectively. If no
> function is set they remain in GPIO mode. These muxes can be overridden
> by requesting them as GPIOs.
>
> Signed-off-by: James Hogan <james.hogan@xxxxxxxxxx>
> Cc: Grant Likely <grant.likely@xxxxxxxxxx>
> Cc: Rob Herring <rob.herring@xxxxxxxxxxx>
> Cc: Rob Landley <rob@xxxxxxxxxxx>
> Cc: Linus Walleij <linus.walleij@xxxxxxxxxx>
> Cc: linux-doc@xxxxxxxxxxxxxxx
> Cc: devicetree-discuss@xxxxxxxxxxxxxxxx
> ---
> Changes in v3:
>  - separated from irq-imgpdc and removed arch/metag changes to allow
>    these patches to go upstream separately via the pinctrl[/gpio] trees
>    (particularly the pinctrl drivers depend on the new pinconf DT
>    bindings).
>  - some s/unsigned/unsigned int/.
>  - pinctrl-tz1090*: switch to generic pinconfig DT bindings and
>    pinconf_generic_dump_config.
>  - pinctrl-tz1090*: use tz1090, prefix for pins and function in DT
>    bindings.
>  - pinctrl-tz1090*: make internal functions static.
>  - pinctrl-tz1090*: move initcall from postcore to arch.

Thanks, patch applied as well.

Yours,
Linus Walleij
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/