On Wed, May 22, 2013 at 10:55:43PM +0200, Sebastian Hesselbarth wrote:On 05/22/2013 10:36 PM, Simon Baatz wrote:Hi Sebastian,...
On Tue, May 21, 2013 at 06:41:49PM +0200, Sebastian Hesselbarth wrote:With DT support for mv643xx_eth, board specific init for some boards now
is unneccessary. Remove those board files, Kconfig entries, and
corresponding entries in kirkwood_defconfig.
Signed-off-by: Sebastian Hesselbarth<sebastian.hesselbarth@xxxxxxxxx>
---
Note: board-km_kirkwood.c is also removed, as Valentin Longchamp confirmed
the lock-up is not caused by accessing clock gating registers but rather
non-existent device registers. This will be addressed by dtsi separation
for kirkwood and bobcat SoC variants.
Changelog:
v3->v4:
- remove more boards that don't require board specific setup
I would stick with "marvell,kirkwood" only. This is SoC init code and
we do not distinguish variants here at all.
Agreed, nice catch Simon.