Re: [PATCH v3 6/7] ARM: kirkwood: add gigabit ethernet and mvmdiodevice tree nodes

From: Sebastian Hesselbarth
Date: Mon May 20 2013 - 17:38:12 EST

On 05/20/2013 11:27 PM, Simon Baatz wrote:
Hi Sebastian,

On Mon, May 06, 2013 at 05:33:39PM +0200, Sebastian Hesselbarth wrote:
This patch adds mv643xx_eth and mvmdio device tree nodes for DT enabled
Kirkwood boards. Phy nodes are also added with reg property set on a
per-board basis.
diff --git a/arch/arm/boot/dts/kirkwood.dtsi b/arch/arm/boot/dts/kirkwood.dtsi
index fada7e6..c01a273 100644
--- a/arch/arm/boot/dts/kirkwood.dtsi
+++ b/arch/arm/boot/dts/kirkwood.dtsi
@@ -202,5 +202,57 @@
clocks =<&gate_clk 4>;
status = "disabled";
+ mdio: mdio-bus@72004 {
+ compatible = "marvell,orion-mdio";
+ reg =<0x72004 0x84>;
+ interrupts =<11>;

Shouldn't this be 46?

Yes, mdio is using GbE0Err interrupt and that is 14 on IRQ HIGH CAUSE.
I was misled by 11 on IRQ LOW CAUSE.

To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at
Please read the FAQ at