Re: [PATCH v4 3/8] ARM: tegra: update device trees for USB bindingrework

From: Stephen Warren
Date: Fri May 17 2013 - 18:06:35 EST

On 05/16/2013 05:02 PM, Stephen Warren wrote:
> On 05/16/2013 08:12 AM, Venu Byravarasu wrote:
>> This patch updates all Tegra board files so that they contain all the
>> properties required by the updated USB DT binding. Note that this patch
>> only adds the new properties and does not yet remove the old properties,
>> in order to maintain bisectability. The old properties will be removed
>> once the driver has been updated to assume the new bindings.
> This series looks almost OK now. The one remaining issue is that in this
> patch, the regulator-name properties don't match the schematics, and in
> the Whistler patch below, both regulators you added have the same
> regulator-name, which causes problems.
> To fix this, when I apply this patch, I'm going to fold in the patch
> I'll paste below.
> Right now, I can't get Whistler to see the SD card. This is true even
> without your patches. Once I've resolved that and tested Whistler,
> assuming no more problems, I'll apply patches 1-3 to the Tegra tree, and
> set up a branch that can be pulled into the USB tree so the rest of the
> series can be applied there.

I've made Whistler boot by reverting a few commits entirely unrelated to
USB or your patch series. I'll investigate those later, but for not your
patches test out fine on Whistler. So, I'll apply patches 1-3 in the
series and set up the pull request for the USB tree. Thanks.
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at
Please read the FAQ at