[PATCH RFC V4 FINAL] media: i2c: mt9p031: add OF support

[Lad Prabhakar]

From: Lad, Prabhakar <prabhakar.csengg@xxxxxxxxx>

add OF support for the mt9p031 sensor driver.
Alongside this patch sorts the header inclusion alphabetically.

Signed-off-by: Lad, Prabhakar <prabhakar.csengg@xxxxxxxxx>
Cc: Hans Verkuil <hans.verkuil@xxxxxxxxx>
Cc: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx>
Cc: Mauro Carvalho Chehab <mchehab@xxxxxxxxxx>
Cc: Guennadi Liakhovetski <g.liakhovetski@xxxxxx>
Cc: Sylwester Nawrocki <s.nawrocki@xxxxxxxxxxx>
Cc: Sakari Ailus <sakari.ailus@xxxxxx>
Cc: Grant Likely <grant.likely@xxxxxxxxxxxx>
Cc: Sascha Hauer <s.hauer@xxxxxxxxxxxxxx>
Cc: Rob Herring <rob.herring@xxxxxxxxxxx>
Cc: Rob Landley <rob@xxxxxxxxxxx>
Cc: Arnd Bergmann <arnd@xxxxxxxx>
Cc: devicetree-discuss@xxxxxxxxxxxxxxxx
Cc: davinci-linux-open-source@xxxxxxxxxxxxxxxxxxxx
Cc: linux-doc@xxxxxxxxxxxxxxx
Cc: linux-kernel@xxxxxxxxxxxxxxx
---
 Changes for v4:
 1: Renamed "gpio-reset" property to "reset-gpios".
 2: Dropped assigning the driver data from the of node.

 Changes for v3:
 1: Dropped check if gpio-reset is valid.
 2: Fixed some code nits.
 3: Included a reference to the V4L2 DT bindings documentation.

 Changes for v2:
 1: Used '-' instead of '_' for device properties.
 2: Specified gpio reset pin as phandle in device node.
 3: Handle platform data properly even if kernel is compiled with
    devicetree support.
 4: Used dev_* for messages in drivers instead of pr_*.
 5: Changed compatible property to "aptina,mt9p031" and "aptina,mt9p031m".
 6: Sorted the header inclusion alphabetically and fixed some minor code nits.

 .../devicetree/bindings/media/i2c/mt9p031.txt      |   40 +++++++++++++++++++
 drivers/media/i2c/mt9p031.c                        |   42 +++++++++++++++++++-
 2 files changed, 80 insertions(+), 2 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/media/i2c/mt9p031.txt

diff --git a/Documentation/devicetree/bindings/media/i2c/mt9p031.txt b/Documentation/devicetree/bindings/media/i2c/mt9p031.txt
new file mode 100644
index 0000000..59d613c
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/i2c/mt9p031.txt
@@ -0,0 +1,40 @@
+* Aptina 1/2.5-Inch 5Mp CMOS Digital Image Sensor
+
+The Aptina MT9P031 is a 1/2.5-inch CMOS active pixel digital image sensor with
+an active array size of 2592H x 1944V. It is programmable through a simple
+two-wire serial interface.
+
+Required Properties :
+- compatible : value should be either one among the following
+	(a) "aptina,mt9p031" for mt9p031 sensor
+	(b) "aptina,mt9p031m" for mt9p031m sensor
+
+- input-clock-frequency : Input clock frequency.
+
+- pixel-clock-frequency : Pixel clock frequency.
+
+Optional Properties :
+- reset-gpios: Chip reset GPIO
+
+For further reading of port node refer Documentation/devicetree/bindings/media/
+video-interfaces.txt.
+
+Example:
+
+	i2c0@1c22000 {
+		...
+		...
+		mt9p031@5d {
+			compatible = "aptina,mt9p031";
+			reg = <0x5d>;
+			reset-gpios = <&gpio3 30 0>;
+
+			port {
+				mt9p031_1: endpoint {
+					input-clock-frequency = <6000000>;
+					pixel-clock-frequency = <96000000>;
+				};
+			};
+		};
+		...
+	};
diff --git a/drivers/media/i2c/mt9p031.c b/drivers/media/i2c/mt9p031.c
index 28cf95b..a58207c 100644
--- a/drivers/media/i2c/mt9p031.c
+++ b/drivers/media/i2c/mt9p031.c
@@ -16,9 +16,11 @@
 #include <linux/delay.h>
 #include <linux/device.h>
 #include <linux/gpio.h>
-#include <linux/module.h>
 #include <linux/i2c.h>
 #include <linux/log2.h>
+#include <linux/module.h>
+#include <linux/of_device.h>
+#include <linux/of_gpio.h>
 #include <linux/pm.h>
 #include <linux/regulator/consumer.h>
 #include <linux/slab.h>
@@ -28,6 +30,7 @@
 #include <media/v4l2-chip-ident.h>
 #include <media/v4l2-ctrls.h>
 #include <media/v4l2-device.h>
+#include <media/v4l2-of.h>
 #include <media/v4l2-subdev.h>
 
 #include "aptina-pll.h"
@@ -928,10 +931,35 @@ static const struct v4l2_subdev_internal_ops mt9p031_subdev_internal_ops = {
  * Driver initialization and probing
  */
 
+static struct mt9p031_platform_data *
+mt9p031_get_pdata(struct i2c_client *client)
+{
+	struct device_node *np;
+	struct mt9p031_platform_data *pdata;
+
+	if (!IS_ENABLED(CONFIG_OF) || !client->dev.of_node)
+		return client->dev.platform_data;
+
+	np = v4l2_of_get_next_endpoint(client->dev.of_node, NULL);
+	if (!np)
+		return NULL;
+
+	pdata = devm_kzalloc(&client->dev, sizeof(struct mt9p031_platform_data),
+			     GFP_KERNEL);
+	if (!pdata)
+		return NULL;
+
+	pdata->reset = of_get_named_gpio(client->dev.of_node, "reset-gpios", 0);
+	of_property_read_u32(np, "input-clock-frequency", &pdata->ext_freq);
+	of_property_read_u32(np, "pixel-clock-frequency", &pdata->target_freq);
+
+	return pdata;
+}
+
 static int mt9p031_probe(struct i2c_client *client,
 			 const struct i2c_device_id *did)
 {
-	struct mt9p031_platform_data *pdata = client->dev.platform_data;
+	struct mt9p031_platform_data *pdata = mt9p031_get_pdata(client);
 	struct i2c_adapter *adapter = to_i2c_adapter(client->dev.parent);
 	struct mt9p031 *mt9p031;
 	unsigned int i;
@@ -1070,8 +1098,18 @@ static const struct i2c_device_id mt9p031_id[] = {
 };
 MODULE_DEVICE_TABLE(i2c, mt9p031_id);
 
+#if IS_ENABLED(CONFIG_OF)
+static const struct of_device_id mt9p031_of_match[] = {
+	{ .compatible = "aptina,mt9p031", },
+	{ .compatible = "aptina,mt9p031m", },
+	{ /* sentinel */ },
+};
+MODULE_DEVICE_TABLE(of, mt9p031_of_match);
+#endif
+
 static struct i2c_driver mt9p031_i2c_driver = {
 	.driver = {
+		.of_match_table = of_match_ptr(mt9p031_of_match),
 		.name = "mt9p031",
 	},
 	.probe          = mt9p031_probe,
-- 
1.7.4.1

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/