Re: [PATCH v5 00/45] CPU hotplug: stop_machine()-free CPU hotplug

From: Vincent Guittot
Date: Mon Feb 18 2013 - 05:24:20 EST


On 15 February 2013 20:40, Srivatsa S. Bhat
<srivatsa.bhat@xxxxxxxxxxxxxxxxxx> wrote:
> Hi Vincent,
>
> On 02/15/2013 06:58 PM, Vincent Guittot wrote:
>> Hi Srivatsa,
>>
>> I have run some tests with you branch (thanks Paul for the git tree)
>> and you will find results below.
>>
>
> Thank you very much for testing this patchset!
>
>> The tests condition are:
>> - 5 CPUs system in 2 clusters
>> - The test plugs/unplugs CPU2 and it increases the system load each 20
>> plug/unplug sequence with either more cyclictests threads
>> - The test is done with all CPUs online and with only CPU0 and CPU2
>>
>> The main conclusion is that there is no differences with and without
>> your patches with my stress tests. I'm not sure that it was the
>> expected results but the cpu_down is already quite low : 4-5ms in
>> average
>>
>
> Atleast my patchset doesn't perform _worse_ than mainline, with respect
> to cpu_down duration :-)

yes exactly and it has pass more than 400 consecutive plug/unplug on
an ARM platform

>
> So, here is the analysis:
> Stop-machine() doesn't really slow down CPU-down operation, if the rest
> of the CPUs are mostly running in userspace all the time. Because, the
> CPUs running userspace workloads cooperate very eagerly with the stop-machine
> dance - they receive the resched IPI, and allow the per-cpu cpu-stopper
> thread to monopolize the CPU, almost immediately.
>
> The scenario where stop-machine() takes longer to take effect is when
> most of the online CPUs are running in kernelspace, because, then the
> probability that they call preempt_disable() frequently (and hence inhibit
> stop-machine) is higher. That's why, in my tests, I ran genload from LTP
> which generated a lot of system-time (system-time in 'top' indicates activity
> in kernelspace). Hence my patchset showed significant improvement over
> mainline in my tests.
>

ok, I hadn't noticed this important point for the test

> However, your test is very useful too, if we measure a different parameter:
> the latency impact on the workloads running on the system (cyclic test).
> One other important aim of this patchset is to make hotplug as less intrusive
> as possible, for other workloads running on the system. So if you measure
> the cyclictest numbers, I would expect my patchset to show better numbers
> than mainline, when you do cpu-hotplug in parallel (same test that you did).
> Mainline would run stop-machine and hence interrupt the cyclic test tasks
> too often. My patchset wouldn't do that, and hence cyclic test should
> ideally show better numbers.

In fact, I haven't looked at the results as i was more interested by
the load that was generated

>
> I'd really appreciate if you could try that out and let me know how it
> goes.. :-) Thank you very much!

ok, I'm going to try to run a test series

Vincent
>
> Regards,
> Srivatsa S. Bhat
>
>>
>>
>> On 12 February 2013 04:58, Srivatsa S. Bhat
>> <srivatsa.bhat@xxxxxxxxxxxxxxxxxx> wrote:
>>> On 02/12/2013 12:38 AM, Paul E. McKenney wrote:
>>>> On Mon, Feb 11, 2013 at 05:53:41PM +0530, Srivatsa S. Bhat wrote:
>>>>> On 02/11/2013 05:28 PM, Vincent Guittot wrote:
>>>>>> On 8 February 2013 19:09, Srivatsa S. Bhat
>>>>>> <srivatsa.bhat@xxxxxxxxxxxxxxxxxx> wrote:
>>>>
>>>> [ . . . ]
>>>>
>>>>>>> Adding Vincent to CC, who had previously evaluated the performance and
>>>>>>> latency implications of CPU hotplug on ARM platforms, IIRC.
>>>>>>>
>>>>>>
>>>>>> Hi Srivatsa,
>>>>>>
>>>>>> I can try to run some of our stress tests on your patches.
>>>>>
>>>>> Great!
>>>>>
>>>>>> Have you
>>>>>> got a git tree that i can pull ?
>>>>>>
>>>>>
>>>>> Unfortunately, no, none at the moment.. :-(
>>>>
>>>> You do need to create an externally visible git tree.
>>>
>>> Ok, I'll do that soon.
>>>
>>>> In the meantime,
>>>> I have added your series at rcu/bhat.2013.01.21a on -rcu:
>>>>
>>>> git://git.kernel.org/pub/scm/linux/kernel/git/paulmck/linux-rcu.git
>>>>
>>>> This should appear soon on a kernel.org mirror near you. ;-)
>>>>
>>>
>>> Thank you very much, Paul! :-)
>>>
>>> Regards,
>>> Srivatsa S. Bhat
>>>
>
>
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/