Re: [PATCH] at24: make module parameters changeable via sysfs

From: Jean Delvare
Date: Fri Sep 14 2012 - 04:25:41 EST


Hi Uwe,

On Wed, 12 Sep 2012 11:43:32 +0200, Uwe Kleine-König wrote:
> The respective values are evaluated at each read/write, so no further
> action is required than to change the perm argument to module_param.
>
> Note there is no sanity check so root can make the driver effectively
> unusable but that's what root is for :-)
>
> Signed-off-by: Uwe Kleine-König <u.kleine-koenig@xxxxxxxxxxxxxx>
> ---
> drivers/misc/eeprom/at24.c | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/misc/eeprom/at24.c b/drivers/misc/eeprom/at24.c
> index ab1ad41..8a5a192 100644
> --- a/drivers/misc/eeprom/at24.c
> +++ b/drivers/misc/eeprom/at24.c
> @@ -85,7 +85,7 @@ struct at24_data {
> * This value is forced to be a power of two so that writes align on pages.
> */
> static unsigned io_limit = 128;
> -module_param(io_limit, uint, 0);
> +module_param(io_limit, uint, S_IRUGO | S_IWUSR);

This won't work. Not only there is no validation of the value, while
there is such a validation (and value adjustment!) in at24_init(); you
seem to not care, but I do. But the more important problem is that
changing io_limit at run-time will only affect reads, not writes. The
size limit from writes is computed at device probing time:

static int at24_probe(struct i2c_client *client, const struct i2c_device_id *id)
{
(...)
if (writable) {
(...)
if (write_max > io_limit)
write_max = io_limit;

So changing the value through sysfs will have no effect. If you want it
to have an effect, you have to move the check from at24_probe() to
at24_eeprom_write().

Back to the validation issue, I think it would be worth looking into
module_param_cb(). Using it, it may not be that difficult to get
validation when the value is changed through sysfs. Otherwise I'll ask
you to check what exactly happens if someone sets io_limit to 0. We
can't afford infinite loops or EEPROM corruption on root mistyping.

> MODULE_PARM_DESC(io_limit, "Maximum bytes per I/O (default 128)");
>
> /*
> @@ -93,7 +93,7 @@ MODULE_PARM_DESC(io_limit, "Maximum bytes per I/O (default 128)");
> * it's important to recover from write timeouts.
> */
> static unsigned write_timeout = 25;
> -module_param(write_timeout, uint, 0);
> +module_param(write_timeout, uint, S_IRUGO | S_IWUSR);

This one is OK.

> MODULE_PARM_DESC(write_timeout, "Time (in ms) to try writes (default 25)");
>
> #define AT24_SIZE_BYTELEN 5


--
Jean Delvare
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/