Re: O_DIRECT to md raid 6 is slow

[NeilBrown]

On Sun, 19 Aug 2012 18:34:28 -0500 Stan Hoeppner <stan@xxxxxxxxxxxxxxxxx>
wrote:

> On 8/19/2012 9:01 AM, David Brown wrote:
> > I'm sort of jumping in to this thread, so my apologies if I repeat
> > things other people have said already.
> 
> I'm glad you jumped in David.  You made a critical statement of fact
> below which clears some things up.  If you had stated it early on,
> before Miquel stole the thread and moved it to LKML proper, it would
> have short circuited a lot of this discussion.  Which is:
> 
> > AFAIK, there is scope for a few performance optimisations in raid6.  One
> > is that for small writes which only need to change one block, raid5 uses
> > a "short-cut" RMW cycle (read the old data block, read the old parity
> > block, calculate the new parity block, write the new data and parity
> > blocks).  A similar short-cut could be implemented in raid6, though it
> > is not clear how much a difference it would really make.
> 
> Thus my original statement was correct, or at least half correct[1], as
> it pertained to md/RAID6.  Then Miquel switched the discussion to
> md/RAID5 and stated I was all wet.  I wasn't, and neither was Dave
> Chinner.  I was simply unaware of this md/RAID5 single block write RMW
> shortcut.  I'm copying lkml proper on this simply to set the record
> straight.  Not that anyone was paying attention, but it needs to be in
> the same thread in the archives.  The takeaway:
> 

Since we are trying to set the record straight....

> md/RAID6 must read all devices in a RMW cycle.

md/RAID6 must read all data devices (i.e. not parity devices) which it is not
going to write to, in an RWM cycle (which the code actually calls RCW -
reconstruct-write).

> 
> md/RAID5 takes a shortcut for single block writes, and must only read
> one drive for the RMW cycle.

md/RAID5 uses an alternate mechanism when the number of data blocks that need
to be written is less than half the number of data blocks in a stripe.  In
this alternate mechansim (which the code calls RMW - read-modify-write),
md/RAID5 reads all the blocks that it is about to write to, plus the parity
block.  It then computes the new parity and writes it out along with the new
data.

> 
> [1}The only thing that's not clear at this point is if md/RAID6 also
> always writes back all chunks during RMW, or only the chunk that has
> changed.

Do you seriously imagine anyone would write code to write out data which it
is known has not changed?  Sad. :-)

NeilBrown

Attachment: signature.asc
Description: PGP signature