Re: [PATCH v3] spi/pl022: add devicetree support

From: Alexandre Pereira da Silva
Date: Mon Jul 02 2012 - 06:31:59 EST


On Sun, Jul 1, 2012 at 5:39 AM, Thierry Reding
<thierry.reding@xxxxxxxxxxxxxxxxx> wrote:
> On Tue, Jun 26, 2012 at 11:05:36AM -0300, Alexandre Pereira da Silva wrote:
>> Add the chipselect array and cur_cs properties to pl022 main structure
>>
>> Add a wrapper function to decide if the cs should be controlled by the
>> cs_control callback or the chipselect gpio
>>
>> Populate chipselect property from cs-gpios
>>
>> Populate master->dev.of_node, so the spi bus can find child spi
>> devices and register them
>>
>> At pl022 setup, fill chip_data structure from dt nodes, if not provided
>> by platform.
>>
>> Signed-off-by: Alexandre Pereira da Silva <aletes.xgr@xxxxxxxxx>
>> Tested-by: Roland Stigge <stigge@xxxxxxxxx>
>> ---
>> Applies to v3.5-rc4
>>
>> Changes since v2:
>> * Use IS_ENABLED instead of #ifdef
>> * Remove bogus const change
>>
>> Changes since v1:
>> * return EPROBE_DEFFER if gpios are not initialized yet
>>
>> Thanks Thierry Reding for reviewing and improvements suggestions
>>
>> .../devicetree/bindings/spi/spi_pl022.txt | 15 +++
>> drivers/spi/spi-pl022.c | 115 ++++++++++++++++----
>> 2 files changed, 111 insertions(+), 19 deletions(-)
>>
> [...]
>> diff --git a/drivers/spi/spi-pl022.c b/drivers/spi/spi-pl022.c
> [...]
>> @@ -1998,8 +2039,14 @@ pl022_probe(struct amba_device *adev, const struct amba_id *id)
>> goto err_no_pdata;
>> }
>>
>> + num_cs = platform_info->num_chipselect;
>> +#if IS_ENABLED(CONFIG_OF)
>> + of_property_read_u32(np, "pl022,num-chipselects", &num_cs);
>> +#endif
>> +
>
> Actually this has even more advantages if you use it as a condition in
> an if expression:
>
> if (IS_ENABLED(CONFIG_OF))
> of_property_read_u32(...);
>
> The above will be compiled wether CONFIG_OF is enabled or not, but it
> will not be included in the final output because of the compiler's DCE
> (dead code elimination) seeing this as "if (0)". The result is that the
> source code gets much better compile coverage and errors in the
> conditional code can be caught earlier.
>
>> @@ -2017,13 +2064,40 @@ pl022_probe(struct amba_device *adev, const struct amba_id *id)
>> * on this board
>> */
>> master->bus_num = platform_info->bus_id;
>> - master->num_chipselect = platform_info->num_chipselect;
>> + master->num_chipselect = num_cs;
>> master->cleanup = pl022_cleanup;
>> master->setup = pl022_setup;
>> master->prepare_transfer_hardware = pl022_prepare_transfer_hardware;
>> master->transfer_one_message = pl022_transfer_one_message;
>> master->unprepare_transfer_hardware = pl022_unprepare_transfer_hardware;
>> master->rt = platform_info->rt;
>> + master->dev.of_node = dev->of_node;
>> +
>> +#if IS_ENABLED(CONFIG_OF)
>> + for (i = 0; i < num_cs; i++) {
>> + int cs_gpio = of_get_named_gpio(np, "cs-gpios", i);
>> +
>> + if (cs_gpio == -EPROBE_DEFER) {
>> + status = -EPROBE_DEFER;
>> + goto err_no_gpio;
>> + }
>> +
>> + pl022->chipselect[i] = cs_gpio;
>> +
>> + if (gpio_is_valid(cs_gpio)) {
>> + if (gpio_request(cs_gpio, "ssp-pl022"))
>> + dev_err(&adev->dev,
>> + "could not request %d gpio\n", cs_gpio);
>> + else if (gpio_direction_output(cs_gpio, 1))
>> + dev_err(&adev->dev,
>> + "could set gpio %d as output\n",
>> + cs_gpio);
>> + }
>> + }
>> +#else
>> + for (i = 0; i < num_cs; i++)
>> + pl022->chipselect[i] = -EINVAL;
>> +#endif
>
> Same here.
>
>> /*
>> * Supports mode 0-3, loopback, and active low CS. Transfers are
>> @@ -2130,6 +2204,9 @@ pl022_probe(struct amba_device *adev, const struct amba_id *id)
>> err_no_ioremap:
>> amba_release_regions(adev);
>> err_no_ioregion:
>> + #if IS_ENABLED(CONFIG_OF)
>> + err_no_gpio:
>> + #endif
>
> And here.

Thanks for the hint. I will update the patch and repost later.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/