Re: [PATCHv4 3/5] kvm: host side for eoi optimization

From: Michael S. Tsirkin
Date: Wed May 16 2012 - 14:29:46 EST


On Wed, May 16, 2012 at 09:25:20PM +0300, Gleb Natapov wrote:
> On Wed, May 16, 2012 at 03:15:00PM -0300, Marcelo Tosatti wrote:
> > On Wed, May 16, 2012 at 08:58:57PM +0300, Michael S. Tsirkin wrote:
> > > On Wed, May 16, 2012 at 02:20:58PM -0300, Marcelo Tosatti wrote:
> > > > On Wed, May 16, 2012 at 07:22:47PM +0300, Michael S. Tsirkin wrote:
> > > > > On Wed, May 16, 2012 at 12:49:40PM -0300, Marcelo Tosatti wrote:
> > > > > > > @@ -1245,9 +1306,20 @@ int kvm_get_apic_interrupt(struct kvm_vcpu *vcpu)
> > > > > > > int vector = kvm_apic_has_interrupt(vcpu);
> > > > > > > struct kvm_lapic *apic = vcpu->arch.apic;
> > > > > > >
> > > > > > > - if (vector == -1)
> > > > > > > + /* Detect interrupt nesting and disable EOI optimization */
> > > > > > > + if (pv_eoi_enabled(vcpu) && vector == -2)
> > > > > > > + pv_eoi_clr_pending(vcpu);
> > > > > > > +
> > > > > > > + if (vector < 0)
> > > > > >
> > > > > > With interrupt window exiting, the guest will exit:
> > > > > >
> > > > > > - as soon as it sets RFLAGS.IF=1 and there is any
> > > > > > interrupt pending in IRR.
> > > > > > - any new interrupt is set in IRR will kick vcpu
> > > > > > out of guest mode and recalculate interrupt-window-exiting.
> > > > > >
> > > > > > Doesnt this make this bit unnecessary ?
> > > > >
> > > > > Looks like we could cut it out. But I'm not sure how architectural it is
> > > > > that we exit on interrupt window.
> > > > > I guess there are reasons to exit on interrupt window but
> > > > > isn't it better to make the feature independent of it?
> > > >
> > > > Hum... not sure. Is it helpful for the Hyper-V interface?
> > > >
> > > > > This almost never happens in my testing anyway, so
> > > > > however we handle it is unlikely to affect performance.
> > > >
> > > > It decreases the amount of state that must be maintained.
> > > >
> > > > BTW there is a bug covered by interrupt window exiting:
> > > >
> > > > vcpu0 host
> > > > - irr 5 set
> > > > - isr 5 set, irr 5 cleared
> > > > - eoi_skip bit not set,
> > > > no other bit set in irr.
> > > > - enter guest
> > > >
> > > > irr 4 set
> > > > kick vcpu0 out of guest mode
> > > >
> > > > - eoi pending bit not set
> > > > (previous interrupt injection
> > > > still pending)
> > > > - skip eoi
> > > >
> > > > If it were not for interrupt window exiting, this would
> > > > inject vector 4 on an unrelated exit who knows how long
> > > > in the future.
> > > >
> > > > Also note optimization depends on the fact that the host
> > > > kicks vcpu out unconditionally (so it is dependent on
> > > > certain kvm implementation details).
> > > >
> > >
> > > Look we can summarize as follows: irq windows exit is
> > > required both before and after this patch.
> > > But it does not make the check above redundant.
> >
> > Right, it is not redundant.
> >
> > The above is still a bug: a case where eoi pending bit is not updated
> > properly.
> When IRR is set while eoi_skip is enabled, eoi_skip should be cleared.
> Michael does your patch do that?

I think this does it:
/* Detect interrupt nesting and disable EOI optimization */
if (pv_eoi_enabled(vcpu) && vector == -2)
pv_eoi_clr_pending(vcpu);

-2 is returned when irr is set.


> >
> > How come is this compatible with hyper-v again? Enlight me.
>
> --
> Gleb.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/