[PATCH] gpio: pch9: Use proper flow type handlers

[Thomas Gleixner]

Jean-Francois Dagenais reported:

 Configuring a gpio pin with the gpio-pch driver with
 "IRQF_TRIGGER_LOW | IRQF_ONESHOT" generates an interrupt storm for
 threaded ISR until the ISR thread actually gets to physically clear
 the interrupt on the triggering chip!! The immediate observable
 symptom is the high CPU usage for my ISR thread task and the
 interrupt count in /proc/interrupts incrementing radically.

The driver is wrong in several ways:

1) Using handle_simple_irq() does not provide proper flow control
   handling. In the case of oneshot threaded handlers for the
   demultiplexed interrupts this results in an interrupt storm because
   the simple handler does not deal with masking/unmasking.  Even
   without threaded oneshot handlers an interrupt storm for level type
   interrupts can easily be triggered when the interrupt is disabled
   and the interrupt line is activated from the device.

2) Acknowlegding the demultiplexed interrupt before calling the
   handler is wrong for level type interrupts.

3) The set_type function unconditionally enables the interrupt. It's
   supposed to set the type and nothing else. The unmasking is done by
   the core code.

Move the acknowledge code into a separate function and add it to the
demux irqchip callbacks.

Remove the unconditional enabling from the set_type() callback and set
the proper flow handlers depending on the selected type (level/edge).

Reported-and-tested-by: Jean-Francois Dagenais <jeff.dagenais@xxxxxxxxx>
Signed-off-by: Thomas Gleixner <tglx@xxxxxxxxxxxxx>
Cc: Tomoya MORINAGA <tomoya-linux@xxxxxxxxxxxxxxx>
Cc: Grant Likely <grant.likely@xxxxxxxxxxxx>
Cc: alexander.stein@xxxxxxxxxxxxxxxxxxxxx
Cc: qi.wang@xxxxxxxxx
Cc: yong.y.wang@xxxxxxxxx
Cc: joel.clark@xxxxxxxxx
Cc: kok.howg.ewe@xxxxxxxxx
Cc: toshiharu-linux@xxxxxxxxxxxxxxx
Link: alpine.LFD.2.02.1204252332070.2542@ionos">http://lkml.kernel.org/r/alpine.LFD.2.02.1204252332070.2542@ionos
---
 drivers/gpio/gpio-pch.c |   57 +++++++++++++++++++++++-------------------------
 1 file changed, 28 insertions(+), 29 deletions(-)

Index: linux-2.6/drivers/gpio/gpio-pch.c
===================================================================
--- linux-2.6.orig/drivers/gpio/gpio-pch.c
+++ linux-2.6/drivers/gpio/gpio-pch.c
@@ -230,16 +230,12 @@ static void pch_gpio_setup(struct pch_gp
 
 static int pch_irq_type(struct irq_data *d, unsigned int type)
 {
-	u32 im;
-	u32 __iomem *im_reg;
-	u32 ien;
-	u32 im_pos;
-	int ch;
-	unsigned long flags;
-	u32 val;
-	int irq = d->irq;
 	struct irq_chip_generic *gc = irq_data_get_irq_chip_data(d);
 	struct pch_gpio *chip = gc->private;
+	u32 im, im_pos, val;
+	u32 __iomem *im_reg;
+	unsigned long flags;
+	int ch, irq = d->irq;
 
 	ch = irq - chip->irq_base;
 	if (irq <= chip->irq_base + 7) {
@@ -270,30 +266,22 @@ static int pch_irq_type(struct irq_data 
 	case IRQ_TYPE_LEVEL_LOW:
 		val = PCH_LEVEL_L;
 		break;
-	case IRQ_TYPE_PROBE:
-		goto end;
 	default:
-		dev_warn(chip->dev, "%s: unknown type(%dd)",
-			__func__, type);
-		goto end;
+		goto unlock;
 	}
 
 	/* Set interrupt mode */
 	im = ioread32(im_reg) & ~(PCH_IM_MASK << (im_pos * 4));
 	iowrite32(im | (val << (im_pos * 4)), im_reg);
 
-	/* iclr */
-	iowrite32(BIT(ch), &chip->reg->iclr);
+	/* And the handler */
+	if (type & (IRQ_TYPE_LEVEL_LOW | IRQ_TYPE_LEVEL_HIGH))
+		__irq_set_handler_locked(d->irq, handle_level_irq);
+	else if (type & (IRQ_TYPE_EDGE_FALLING | IRQ_TYPE_EDGE_RISING))
+		__irq_set_handler_locked(d->irq, handle_edge_irq);
 
-	/* IMASKCLR */
-	iowrite32(BIT(ch), &chip->reg->imaskclr);
-
-	/* Enable interrupt */
-	ien = ioread32(&chip->reg->ien);
-	iowrite32(ien | BIT(ch), &chip->reg->ien);
-end:
+unlock:
 	spin_unlock_irqrestore(&chip->spinlock, flags);
-
 	return 0;
 }
 
@@ -313,18 +301,24 @@ static void pch_irq_mask(struct irq_data
 	iowrite32(1 << (d->irq - chip->irq_base), &chip->reg->imask);
 }
 
+static void pch_irq_ack(struct irq_data *d)
+{
+	struct irq_chip_generic *gc = irq_data_get_irq_chip_data(d);
+	struct pch_gpio *chip = gc->private;
+
+	iowrite32(1 << (d->irq - chip->irq_base), &chip->reg->iclr);
+}
+
 static irqreturn_t pch_gpio_handler(int irq, void *dev_id)
 {
 	struct pch_gpio *chip = dev_id;
 	u32 reg_val = ioread32(&chip->reg->istatus);
-	int i;
-	int ret = IRQ_NONE;
+	int i, ret = IRQ_NONE;
 
 	for (i = 0; i < gpio_pins[chip->ioh]; i++) {
 		if (reg_val & BIT(i)) {
 			dev_dbg(chip->dev, "%s:[%d]:irq=%d  status=0x%x\n",
 				__func__, i, irq, reg_val);
-			iowrite32(BIT(i), &chip->reg->iclr);
 			generic_handle_irq(chip->irq_base + i);
 			ret = IRQ_HANDLED;
 		}
@@ -343,6 +337,7 @@ static __devinit void pch_gpio_alloc_gen
 	gc->private = chip;
 	ct = gc->chip_types;
 
+	ct->chip.irq_ack = pch_irq_ack;
 	ct->chip.irq_mask = pch_irq_mask;
 	ct->chip.irq_unmask = pch_irq_unmask;
 	ct->chip.irq_set_type = pch_irq_type;
@@ -357,6 +352,7 @@ static int __devinit pch_gpio_probe(stru
 	s32 ret;
 	struct pch_gpio *chip;
 	int irq_base;
+	u32 msk;
 
 	chip = kzalloc(sizeof(*chip), GFP_KERNEL);
 	if (chip == NULL)
@@ -408,8 +404,13 @@ static int __devinit pch_gpio_probe(stru
 	}
 	chip->irq_base = irq_base;
 
+	/* Mask all interrupts, but enable them */
+	msk = (1 << gpio_pins[chip->ioh]) - 1;
+	iowrite32(msk, &chip->reg->imask);
+	iowrite32(msk, &chip->reg->ien);
+
 	ret = request_irq(pdev->irq, pch_gpio_handler,
-			     IRQF_SHARED, KBUILD_MODNAME, chip);
+			  IRQF_SHARED, KBUILD_MODNAME, chip);
 	if (ret != 0) {
 		dev_err(&pdev->dev,
 			"%s request_irq failed\n", __func__);
@@ -418,8 +419,6 @@ static int __devinit pch_gpio_probe(stru
 
 	pch_gpio_alloc_generic_chip(chip, irq_base, gpio_pins[chip->ioh]);
 
-	/* Initialize interrupt ien register */
-	iowrite32(0, &chip->reg->ien);
 end:
 	return 0;
 
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/