Uncompressing Linux... done, booting the kernel. Linux version 2.6.39-rc4-00017-g4fcd3f3-dirty (ambro@localhost) (gcc version 4.4.5 (Gentoo 4.4.5 p1.3, pie-0.4.5) ) #18 PREEMPT S012 CPU: Feroceon [41069260] revision 0 (ARMv5TEJ), cr=b0053177 CPU: VIVT data cache, VIVT instruction cache Machine: Technologic Systems TS-78xx SBC Memory policy: ECC disabled, Data cache writeback Built 1 zonelists in Zone order, mobility grouping on. Total pages: 32512 Kernel command line: console=ttyS0,115200 root=UUID=730c20aa-3bb6-4f8b-86e6-072eafb705e5 PID hash table entries: 512 (order: -1, 2048 bytes) Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) Memory: 128MB = 128MB total Memory: 121696k/121696k available, 9376k reserved, 0K highmem Virtual kernel memory layout: vector : 0xffff0000 - 0xffff1000 ( 4 kB) fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB) DMA : 0xffc00000 - 0xffe00000 ( 2 MB) vmalloc : 0xc8800000 - 0xfd800000 ( 848 MB) lowmem : 0xc0000000 - 0xc8000000 ( 128 MB) modules : 0xbf000000 - 0xc0000000 ( 16 MB) .init : 0xc0008000 - 0xc002b000 ( 140 kB) .text : 0xc002b000 - 0xc03c81e8 (3701 kB) .data : 0xc03ca000 - 0xc03eb860 ( 135 kB) SLUB: Genslabs=13, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 Preemptable hierarchical RCU implementation. RCU-based detection of stalled CPUs is disabled. Verbose stalled-CPUs detection is disabled. NR_IRQS:64 sched_clock: 32 bits at 166MHz, resolution 5ns, wraps every 25769ms Calibrating delay loop... 331.77 BogoMIPS (lpj=1658880) pid_max: default: 32768 minimum: 301 Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok devtmpfs: initialized NET: Registered protocol family 16 Orion ID: MV88F5182-A2. TCLK=166666667. TS-78xx FPGA: magic=0x00b480, rev=0x03 bio: create slab at 0 SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb Switching to clocksource orion_clocksource NET: Registered protocol family 2 Switched to NOHz mode on CPU #0 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) IPv4 FIB: Using LC-trie version 0.409 TCP established hash table entries: 4096 (order: 3, 32768 bytes) TCP bind hash table entries: 4096 (order: 2, 16384 bytes) TCP: Hash tables configured (established 4096 bind 4096) TCP reno registered UDP hash table entries: 256 (order: 0, 4096 bytes) UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) NET: Registered protocol family 1 Unpacking initramfs... Initramfs unpacking failed: junk in compressed archive Freeing initrd memory: 4096K NetWinder Floating Point Emulator V0.97 (double precision) JFFS2 version 2.2. (NAND) © 2001-2006 Red Hat, Inc. msgmni has been set to 245 io scheduler noop registered io scheduler deadline registered io scheduler cfq registered (default) Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO 0xf1012000 (irq = 3) is a 16550A console [ttyS0] enabled serial8250.1: ttyS1 at MMIO 0xf1012100 (irq = 4) is a 16550A loop: module loaded sata_mv sata_mv.0: version 1.28 sata_mv sata_mv.0: slots 32 ports 2 scsi0 : sata_mv scsi1 : sata_mv ata1: SATA max UDMA/133 irq 29 ata2: SATA max UDMA/133 irq 29 NAND device: Manufacturer ID: 0x2c, Chip ID: 0xdc (Micron NAND 512MiB 3,3V 8-bit) Creating 4 MTD partitions on "gen_nand": 0x000000000000-0x000000020000 : "mbr" 0x000000020000-0x000000420000 : "kernel" 0x000000420000-0x000000820000 : "initrd" 0x000000820000-0x000020000000 : "rootfs" mv643xx_eth: MV-643xx 10/100/1000 ethernet driver version 1.4 mv643xx_eth smi: probed mv643xx_eth_port mv643xx_eth_port.0: eth0: port 0 with MAC address 00:d0:69:40:cc:e7 tun: Universal TUN/TAP device driver, 1.6 tun: (C) 1999-2004 Max Krasnyansky ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver orion-ehci orion-ehci.0: Marvell Orion EHCI orion-ehci orion-ehci.0: new USB bus registered, assigned bus number 1 orion-ehci orion-ehci.0: irq 17, io mem 0xf1050000 orion-ehci orion-ehci.0: USB 2.0 started, EHCI 1.00 hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected orion-ehci orion-ehci.1: Marvell Orion EHCI orion-ehci orion-ehci.1: new USB bus registered, assigned bus number 2 orion-ehci orion-ehci.1: irq 12, io mem 0xf10a0000 orion-ehci orion-ehci.1: USB 2.0 started, EHCI 1.00 hub 2-0:1.0: USB hub found hub 2-0:1.0: 1 port detected usbcore: registered new interface driver usblp Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. usbcore: registered new interface driver ums-datafab usbcore: registered new interface driver ums-freecom usbcore: registered new interface driver ums-jumpshot usbcore: registered new interface driver ums-sddr09 usbcore: registered new interface driver ums-sddr55 rtc-m48t86 rtc-m48t86: rtc core: registered m48t86 as rtc0 rtc-m48t86 rtc-m48t86: battery ok i2c /dev entries driver mv_xor_shared mv_xor_shared.0: Marvell shared XOR driver ata1: SATA link down (SStatus 0 SControl 300) mv_xor mv_xor.0: Marvell XOR: ( xor cpy ) mv_xor mv_xor.1: Marvell XOR: ( xor fill cpy ) usbcore: registered new interface driver usbhid usbhid: USB HID core driver oprofile: hardware counters not available oprofile: using timer interrupt. TCP cubic registered NET: Registered protocol family 17 VFP support v0.3: not present rtc-m48t86 rtc-m48t86: setting system clock to 2012-02-04 00:06:56 UTC (1328314016) ata2: SATA link down (SStatus 0 SControl 300) Freeing init memory: 140K ainitramfs: Mounting filesystems ainitramfs: Running depmod ainitramfs: Starting udev udevd[380]: starting version 180 ainitramfs: Waiting for root device usb 1-1: new high speed USB device number 2 using orion-ehci usb 1-1: device descriptor read/all, error -71 usb 1-1: new high speed USB device number 3 using orion-ehci usb 1-1: device descriptor read/64, error -71 usb 1-1: device descriptor read/64, error -71 usb 1-1: new high speed USB device number 4 using orion-ehci usb 1-1: device descriptor read/8, error -71 usb 1-1: device descriptor read/8, error -71 usb 1-1: new high speed USB device number 5 using orion-ehci usb 1-1: device descriptor read/8, error -71 usb 1-1: device descriptor read/8, error -71 hub 1-0:1.0: unable to enumerate USB device on port 1