Re: [PATCH v2 6/7] clk: Add initial WM831x clock driver

From: Grant Likely
Date: Sun Sep 25 2011 - 00:08:54 EST


On Thu, Sep 22, 2011 at 03:27:01PM -0700, Mike Turquette wrote:
> From: Mark Brown <broonie@xxxxxxxxxxxxxxxxxxxxxxxxxxx>
>
> The WM831x and WM832x series of PMICs contain a flexible clocking
> subsystem intended to provide always on and system core clocks. It
> features:
>
> - A 32.768kHz crystal oscillator which can optionally be used to pass
> through an externally generated clock.
> - A FLL which can be clocked from either the 32.768kHz oscillator or
> the CLKIN pin.
> - A CLKOUT pin which can bring out either the oscillator or the FLL
> output.
> - The 32.768kHz clock can also optionally be brought out on the GPIO
> pins of the device.
>
> This driver fully supports the 32.768kHz oscillator and CLKOUT. The FLL
> is supported only in AUTO mode, the full flexibility of the FLL cannot
> currently be used. The use of clock references other than the internal
> oscillator is not currently supported, and since clk_set_parent() is not
> implemented in the generic clock API the clock tree configuration cannot
> be changed at runtime.
>
> Due to a lack of access to systems where the core SoC has been converted
> to use the generic clock API this driver has been compile tested only.
>
> Signed-off-by: Mark Brown <broonie@xxxxxxxxxxxxxxxxxxxxxxxxxxx>
> Signed-off-by: Mike Turquette <mturquette@xxxxxx>

A few minor comments below. Otherwise looks fine to me.

> +static __devinit int wm831x_clk_probe(struct platform_device *pdev)
> +{
> + struct wm831x *wm831x = dev_get_drvdata(pdev->dev.parent);
> + struct wm831x_clk *clkdata;
> + int ret;
> +
> + clkdata = kzalloc(sizeof(*clkdata), GFP_KERNEL);

If devm_kzalloc() is used, then all the kfree unwinding can be
dropped.

> +static int __init wm831x_clk_init(void)
> +{
> + int ret;
> +
> + ret = platform_driver_register(&wm831x_clk_driver);
> + if (ret != 0)
> + pr_err("Failed to register WM831x clock driver: %d\n", ret);
> +
> + return ret;

No need for this song-and-dance. The driver core is pretty well
debugged. Just use "return platform_driver_register(...);"

g.
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/