Re: [PATCH 4/4] mm: vmscan: Only read new_classzone_idx from pgdatwhen reclaiming successfully

From: Mel Gorman
Date: Thu Jul 21 2011 - 12:07:32 EST


On Fri, Jul 22, 2011 at 12:30:07AM +0900, Minchan Kim wrote:
> On Wed, Jul 20, 2011 at 11:48:47AM +0100, Mel Gorman wrote:
> > On Wed, Jul 20, 2011 at 01:09:03AM +0900, Minchan Kim wrote:
> > > Hi Mel,
> > >
> > > Too late review.
> >
> > Never too late.
> >
> > > At that time, I had no time to look into this patch.
> > >
> > > On Fri, Jun 24, 2011 at 03:44:57PM +0100, Mel Gorman wrote:
> > > > During allocator-intensive workloads, kswapd will be woken frequently
> > > > causing free memory to oscillate between the high and min watermark.
> > > > This is expected behaviour. Unfortunately, if the highest zone is
> > > > small, a problem occurs.
> > > >
> > > > When balance_pgdat() returns, it may be at a lower classzone_idx than
> > > > it started because the highest zone was unreclaimable. Before checking
> > >
> > > Yes.
> > >
> > > > if it should go to sleep though, it checks pgdat->classzone_idx which
> > > > when there is no other activity will be MAX_NR_ZONES-1. It interprets
> > >
> > > Yes.
> > >
> > > > this as it has been woken up while reclaiming, skips scheduling and
> > >
> > > Hmm. I can't understand this part.
> > > If balance_pgdat returns lower classzone and there is no other activity,
> > > new_classzone_idx is always MAX_NR_ZONES - 1 so that classzone_idx would be less than
> > > new_classzone_idx. It means it doesn't skip scheduling.
> > >
> > > Do I miss something?
> > >
> >
> > It was a few weeks ago so I don't rememember if this is the exact
> > sequence I had in mind at the time of writing but an example sequence
> > of events is for a node whose highest populated zone is ZONE_NORMAL,
> > very small, and gets set all_unreclaimable by balance_pgdat() looks
> > is below. The key is the "very small" part because pages are getting
> > freed in the zone but the small size means that unreclaimable gets
> > set easily.
> >
> > /*
> > * kswapd is woken up for ZONE_NORMAL (as this is the preferred zone
> > * as ZONE_HIGHMEM is not populated.
> > */
> >
> > order = pgdat->kswapd_max_order;
> > classzone_idx = pgdat->classzone_idx; /* classzone_idx == ZONE_NORMAL */
> > pgdat->kswapd_max_order = 0;
> > pgdat->classzone_idx = MAX_NR_ZONES - 1;
> > order = balance_pgdat(pgdat, order, &classzone_idx); /* classzone_idx == ZONE_NORMAL even though
> > * the highest zone was set unreclaimable
> > * and it exited scanning ZONE_DMA32
> > * because we did not communicate that
> > * information back
>
> Yes. It's too bad.
>
> > */
> > new_order = pgdat->kswapd_max_order; /* new_order = 0 */
> > new_classzone_idx = pgdat->classzone_idx; /* new_classzone_idx == ZONE_HIGHMEM
> > * because that is what classzone_idx
> > * gets reset to
>
> Yes. new_classzone_idx is ZONE_HIGHMEM.
>
> > */
> > if (order < new_order || classzone_idx > new_classzone_idx) {
> > /* does not sleep, this branch not taken */
> > } else {
> > /* tries to sleep, goes here */
> > try_to_sleep(ZONE_NORMAL)
> > sleeping_prematurely(ZONE_NORMAL) /* finds zone unbalanced so skips scheduling */
> > order = pgdat->kswapd_max_order;
> > classzone_idx = pgdat->classzone_idx; /* classzone_idx == ZONE_HIGHMEM now which
> > * is higher than what it was originally
> > * woken for
> > */
>
> But is it a problem?
> it should be reset to ZONE_NORMAL in balance_pgdat as high zone isn't populated.

At the very least, it's sloppy.

> > }
> >
> > /* Looped around to balance_pgdat() again */
> > order = balance_pgdat()
> >
> > Between when all_unreclaimable is set and before before kswapd
> > goes fully to sleep, a page is freed clearing all_reclaimable so
> > it rechecks all the zones, find the highest one is not balanced and
> > skip scheduling.
>
> Yes and it could be repeated forever.

Resulting in chewing up large amounts of CPU.

> Apparently, we should fix wit this patch but I have a qustion about this patch.
>
> Quote from your patch
>
> > diff --git a/mm/vmscan.c b/mm/vmscan.c
> > index a76b6cc2..fe854d7 100644
> > --- a/mm/vmscan.c
> > +++ b/mm/vmscan.c
> > @@ -2448,7 +2448,6 @@ loop_again:
> > if (!zone_watermark_ok_safe(zone, order,
> > high_wmark_pages(zone), 0, 0)) {
> > end_zone = i;
> > - *classzone_idx = i;
> > break;
> > }
> > }
> > @@ -2528,8 +2527,11 @@ loop_again:
> > total_scanned > sc.nr_reclaimed + sc.nr_reclaimed / 2)
> > sc.may_writepage = 1;
> >
> > - if (zone->all_unreclaimable)
> > + if (zone->all_unreclaimable) {
> > + if (end_zone && end_zone == i)
> > + end_zone--;
>
> Until now, It's good.
>
> > continue;
> > + }
> >
> > if (!zone_watermark_ok_safe(zone, order,
> > high_wmark_pages(zone), end_zone, 0)) {
> > @@ -2709,8 +2711,8 @@ static void kswapd_try_to_sleep(pg_data_t *pgdat, int order, int classzone_idx)
> > */
> > static int kswapd(void *p)
> > {
> > - unsigned long order;
> > - int classzone_idx;
> > + unsigned long order, new_order;
> > + int classzone_idx, new_classzone_idx;
> > pg_data_t *pgdat = (pg_data_t*)p;
> > struct task_struct *tsk = current;
> >
> > @@ -2740,17 +2742,23 @@ static int kswapd(void *p)
> > tsk->flags |= PF_MEMALLOC | PF_SWAPWRITE | PF_KSWAPD;
> > set_freezable();
> >
> > - order = 0;
> > - classzone_idx = MAX_NR_ZONES - 1;
> > + order = new_order = 0;
> > + classzone_idx = new_classzone_idx = pgdat->nr_zones - 1;
> > for ( ; ; ) {
> > - unsigned long new_order;
> > - int new_classzone_idx;
> > int ret;
> >
> > - new_order = pgdat->kswapd_max_order;
> > - new_classzone_idx = pgdat->classzone_idx;
> > - pgdat->kswapd_max_order = 0;
> > - pgdat->classzone_idx = MAX_NR_ZONES - 1;
> > + /*
> > + * If the last balance_pgdat was unsuccessful it's unlikely a
> > + * new request of a similar or harder type will succeed soon
> > + * so consider going to sleep on the basis we reclaimed at
> > + */
> > + if (classzone_idx >= new_classzone_idx && order == new_order) {
> > + new_order = pgdat->kswapd_max_order;
> > + new_classzone_idx = pgdat->classzone_idx;
> > + pgdat->kswapd_max_order = 0;
> > + pgdat->classzone_idx = pgdat->nr_zones - 1;
> > + }
> > +
>
> But in this part.
> Why do we need this?

Lets say it's a fork-heavy workload and it is routinely being woken
for order-1 allocations and the highest zone is very small. For the
most part, it's ok because the allocations are being satisfied from
the lower zones which kswapd has no problem balancing.

However, by reading the information even after failing to
balance, kswapd continues balancing for order-1 due to reading
pgdat->kswapd_max_order, each time failing for the highest zone. It
only takes one wakeup request per balance_pgdat() to keep kswapd
awake trying to balance the highest zone in a continual loop.

By avoiding this read, kswapd will try and go to sleep after checking
all the watermarks and all_unreclaimable. If the watermarks are ok, it
will sleep until woken up due to the lower zones hitting their min
watermarks.

--
Mel Gorman
SUSE Labs
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/